![](/images/new-backgrounds/1109852/10985245x1.webp)
Barracuda 50 Installation Guide, Rev. A | 21 |
3.Configure termination power.
Terminators have to get power from some source. The default configuration results in the drive not suppling termi- nation power to the bus. You should normally leave this drive set at this default unless your host system requires that the drive supply termination power to the bus.
To configure this drive to supply termination power to the bus, place a jumper on J2 pins 1 and 2 as shown in the fig- ure below.
J2
R R
S D MW P E E T
E S E P D S S P
Pin 1 Pin 2
Term. Power to SCSI Bus
Host adapter or other device provides term power to external terminator
J2 Jumper (enlarged to
show detail)
J2
J6
Drive
Front