Seagate ST19101N/W/WC/WD/DC manual Drive models, General information

20 Cheetah 9 Installation Guide, Rev. B

Initial setup information

The general information beginning on this page applies to all of the Cheetah 9 drive models. After reading the general informa- tion topics, refer to the appropriate drive-specific section listed below for additional information about configuring and installing your particular model.

Drive models	Page
ST19101N	39
ST19101W/WD	43
ST19101WC/DC	48

General information

The following general information topics are discussed:

•SCSI ID jumpers

•Drive termination

•Terminator power

•Interface drivers and data path width notes

•Other applicable jumper options

•Providing adequate cooling

•Mounting the drive and connecting cables1

•Formatting the drive

1This mounting procedure does not apply to “WC” or “DC” model drives. To mount a “WC” or “DC” drive, plug the drive into the system’s single connector attachment (SCA) position on the system’s back panel.