2.8Power specifications
The drive receives DC power (+5V or +12V) through a native SATA power connector. See Figure 4 on page 18.
2.8.1Power consumption
Power requirements for the drives are listed in the table on page 9. Typical power measurements are based on an average of drives tested, under nominal conditions, using 5.0V and 12.0V input voltage at 25°C ambient temperature.
• Spinup power
Spinup power is measured from the time of
• Idle mode power
Idle mode power is measured with the drive up to speed, with servo electronics active and with the heads in a random track location.
• Operating (CE seek profile)
Operating power is measured by simulating a typical PVR operating environment, using a 50% write 50% read algorithm.
• Standby mode
During Standby mode, the drive accepts commands, but the drive is not spinning, and the servo and read/ write electronics are in
Table 2: | DC power requirements |
|
|
|
|
|
|
| |
Power dissipation | Avg (watts 25° C) | Avg 5V typ amps | Avg 12V typ amps | |
|
|
|
|
|
Spinup |
| — | — | 2.0 (peak) |
|
|
|
|
|
Idle* |
| 5.33 | 0.415 | 0.272 |
|
|
|
| |
Operating (CE seek profile) | 7.97 | 0.641 | 0.397 | |
|
|
|
|
|
Standby |
| 1.06 | 0.115 | 0.040 |
|
|
|
|
|
Sleep |
| 1.06 | 0.115 | 0.040 |
|
|
|
|
|
*During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels.
8 | DB35.4 Series SATA Product Manual, Rev. B |
