Cheetah 9LP Installation Guide, Rev. B 19
Initial setup information
The general information beginning on this page applies to all of
the Cheetah 9LP drive models. After reading the general infor-
mation topics, refer to the appropriate drive-specific section
listed below for additional information about configuring and
installing your particular model.

Drive models Page

ST39102LW and ST34502LW 40
ST39102LC and ST34502LC 46

General information

The following general information topics are discussed:
• Single-ended and low voltage differential modes
• SCSI ID jumpers
• Drive ter mination
• Terminator power
• Interface drivers and data path width notes
• Other applicable jumper options
• Providing adequate cooling
• Mounting the drive and connecting cables1
• Formatting the drive
1This mounting procedure does not apply to “LC” model drives.
To mount an “LC” drive, plug the drive into the system’s single
connector attachment (SCA) position on the system’s back
panel.