Sears 134176300 installation instructions Bracket, Dryer Installation

NOTE: The washer/pedestal assembly MUST be on a solid floor and level for proper operation. Turn the lock

nut on each leveling leg up towards the pedestal base and snug with a wrench. Keep the leg extension

at a minimum to prevent excessive vibration.

Dryer Installation

1.Remove the pedestal, installation hardware and instructions from the shipping carton.

2.Carefully lay the dryer on it's back.

3.Using the small flat blade screwdriver, carefully remove the hole plugs located in the bottom of the dryer front panel.

4.Remove the four (4) leveling legs from the dryer base and discard.

5.Install the four (4) leveling legs (supplied with the kit) fully into the pedestal.

6.Using four (4) 8-18 x 3/8" screws (supplied with the kit), attached the rear mounting brackets to the pedestal.

7. Using four (4) 8-18 x 3/8" screws (supplied with the kit), attach the front mounting brackets to the pedestal.

Bracket

8.Place the dryer on top of the pedestal. Slide the back of the dryer into the rear brackets, then drop the front down behind the front brackets.

9.Insert the two (2) screws 10-16 x .75" (supplied with the kit) through the holes in the dryer front panel and install into the front mounting brackets.

10.Reinstall the hole plugs removed in step 3.

11.Reconnect the dryer to the existing facilities and/or refer to the installation instructions that came with the dryer for proper installation.

NOTE: The dryer/pedestal assembly MUST be on a solid floor and level for proper operation. Turn the lock nut on each leveling leg up towards the pedestal base and snug with a wrench. Keep the leg extension at a minimum to prevent excessive vibration.

134176300 8/02