OPERATION

3.Hold the Hose Collar in one hand and with thumb and finger press in both latches on the Hose Collar. (figure 14)

With the latches pressed in, use the other hand to pull the Wand out of the Hose Collar. (Figure 14)

Helpful Hint

For easier remova/ of the Wand, rotate it as you puff it out of the Hose Co//ar.

4.Insert the desired attachment into the Hose Collar. (Figure 15)

NOTE: It is not necessary to press in the latches when inserting or removing the attachments or when re-inserting the Cleaning Wand.

5.To re-assemble the Wand, simply re-insert the Wand back into the Hose Collar. (Figure 2)

WAND

LATCHES FIGURE14

J. EMPTYING THE COLLECTION BIN

The DESTINY _ PLUS vacuum cleaner has a see through

Collection Bin with a Maximum Fill line indicated on it, so you know exactly when the bin needs to be emptied of its collected

dirt. It is best to empty the Collection Bin before the dirt rises to this line.

NOTE: Be sure the machine is off before removing or replacing the Collection Bin.

To remove the Collection Bin from the base of the machine, simply insert your fingers under the Collection Bin Catch, lift up and out, and pull away.

(Figure 16)

Empty the collected dirt into a trash can. Make sure to empty the dirt from both the Outer and Inner Collection Chambers. (Figure 16)

Before returning the Bin to the machine:

-Make sure all the dirt has been removed from the Collection Bin.

-Remove any dirt or lint that may have accumulated at the entrance to the outer cyclone. (Figure 17)

-Clear the Screen Holes on the Cone of any dirt or lint that may have accumulated. (Figure 17)

Then, return the Collection Bin to its original position. Make sure the Bin Catch locks into place on the machine. If the Bin is not securely in place, a loss of suction may occur during vacuuming.

K. KEEPING THE ROTATING BRUSH CLEAN.

The Rotating Brush is designed to perform effectively for long periods of time. However, hair, string, and debris can accumulate. It is recommended that you occasionally check the brush for accumulation. Note: Be sure to unplug the

machine before removing any debris. See the MAINTENANCE SECTIONof this manual for the removal of

debris and blockages. (Figure 18)

L. OVERLOAD PROTECTION.

The DESTINY e PLUS machine has an overload protection system that is designed to shut the motor off if it _ssubjected to any excessive load.

If the machine shuts itself off, unplug the machine and proceed to check for a blocka.ge. See the following MAINTENANCE SECTION for removing a blockage.

Before the machine can be switched on again, the Reset Button must be pressed in. (Figure 19)

OUTERCOLLECTION

CHAMBER

NNER ;OLLECTIOI _HAMBER

FIGURE16

FIGURE18

BASE

COVER

SCREW

FIGURE19

FIGURE15

CYCLEENTRANCE

iFIGURE17

BASE

COVER

/SCREW

RESET

BU'I'I'ON

7

Page 9
Image 9
Sears 204.3699969 owner manual Emptying the Collection BIN, Keeping the Rotating Brush Clean, Overload Protection