IMPORTANT: WE ADVISE YOU TO ASSEMBLE THE TENT ONCE BEFORE GOING CAMPING TO BECOME FAM" IAR WITH THI"
ASSEMBLY OF THE TENT. FOR THIS MODEL. IT IS RECOMMENOEDTWO PEOPLE BE INVOLVED IN SE'I'rlNG UPTHISTENT
NOTE: PLEASE LOOK ATTHE REPLACEMENT PARTS DIAGRAM TO SEE HOWYOUR FRAME HAS BEEN COLOR CODED FOR EASY SET UP.
•To prolong the life of the tent floor, select a level, clean area for the campsite.
•To prevent damage to the zipper, unzip the doors and window flaps to allow air to enter the tent.
STEP 1: Separate all frame sections by color.
STEP 2: Spread tent out flat, floor side down.
Stake downtent by insertingstakesthroughstake loops at each corner,Hammer stakes intothe
groundat a 45° angle by using a hammer or mallet.Make sure to pull tent out even and tight.
Stake down remaining loops.
STEP 3: The top center section of the frame, called the "center ddge pole',consists of two bent sections, color coded red, one with plain end and one with swage.
Join these sections together by sliding the straight end of each pole through the loop and into the sleeve at opposite ends on the center of the roof.
Pull loops over curve and attach to
STEP 4: Locate "side ridge poles", color coded blue. The side ridges of the tent have 3 sleeves. Repeat
above step 3, inserting poles through comer loops and then the sleeves.
NOTE:
STEP 5:
STEP 6:
Make sure pole sleeves do not catch on pole while inserting.
There are two center upright sections, color coded red. The center upright section consists of two straight poles corded together and one friction lock pole (this has a plastic clamp attached at one end).
Extend Iwo straight sections and insert one with the reduced end up, through the plastic clamp and into the steel pole section. Repeat with the remaining upright section.
Join each upright section to the curved end of the- center ridge pole.
With the help of another, on the opposite side, lift and push up on the upright sections to raise tent. Adjust center height by adjusting friction locks.
Once raised, clip tent to frame.
