Sears 308.70109 owner manual Assembled, Step

IMPORTANT: WE ADVISE YOU TO ..&.._FMBLE THE TEN T ONCE BEFORE GOING CAMPING TO BECOME FAMILIAR .WI'_I_13HE ASSEMBLY OFTHETENT. FOR THIS MODEL. IT IS RECOMMFNDED TWO PEOPLE_BE INVOLVED IN SETI'ING UP THISTENT.

NOTE: PLEASE LOOK ATTHE REPLACEMENT PARTS DIAGRAMTO SEE HOWYOUR FRAME IS

ASSEMBLED.

•To prolong the lile of the tent floor, select a level, clean area for the campsite.

•To wevent damage to the zipper, unzip the doom and window flaps to allow air to enter the tent.

STEP 1:	Spreadfly of tent out on the groundso the
	undersideof the fly is facing up.
STEP 2:	Locatethe twof_erg[assfly polese=ions. Each pole
	sectionis shock corded together.Extendeach
	section.Insertthe ends ofthe longerfiberglasspole
	intothe pocketslocatedat the sides ofthe fly- Insert
	the ends of the remainingfiberglasspole intothe
	pocketslocatedat the front and rear of the fly.

STEP 6:

STEP 7:

Secure fly to frame by fastening the self-fastenem on the fly around the metal frame,

With the help of another person, flip fly over so it is updght. Attach the "J" hooks on the comers of the fly into the open ends of the metal uprights. Adjust tension as necessary.

STEP 3:

STEP 4:

STEP 5:

Each of the ridge poles of the tent consists of four metal sections chain corded together. Carefully extend each of the sections by joining them together

at the swages to form each section into the shape of an arc. Slide each section through the sleeves on

the fly_

STEP 8: Lay tent out under the fly with the roof side up. Unzip doom. Standing on the floor of the tent, hook the center hook of the tent to the tent frame and work your way out to the comers of the tent, clipping tent hooks around the frame.

Using ties located in the center or fly, tie the

fiberglass and metal poles into place.STEP 9" Insert the pins attached at each comer of the tent into the open ends of each frame pole,

Lo_te the four metal pole sections. Each section consists of three poles chain corded together. Extend each section. While leaving fly on the ground, join the bent end of the metal section to one end of the metal ddge pole sections, which were inserted into the fly sleeves. Repeat for the remaining three pole uprights.

I • II I II