KNOW YOUR UNIT

Allen Wrench

Pruner Blade

Shaft Housing

Blade Cover

Nut Washer

Hook

Hanger

Extension Boom

Craftsman Convertible™

 

 

Coupler

ASSEMBLY INSTRUCTIONS

INSTALLING / REMOVING THE ATTACHMENT

WARNING: Prior to operation, read and understand the operator’s manual for unit to be used with this attachment.

The Bladed Pruner Attachment may be mounted to different power tools. The instruction manuals for the basic power tool and the attachment contain the information necessary for operation of the power tool combination. Therefore, always read BOTH instruction manuals before using the power tool for the first time. Keep the manuals in a safe place for future reference.

NOTE: To make installing or removing the attachment easier, place the unit on the ground or on a work bench.

WARNING: To avoid serious personal injury and damage to the unit, shut the unit off before removing or

Primary Hole

Release Button

Coupler

Upper Shaft Housing

Knob

Lower Shaft Housing

Fig. 2

WARNING: To avoid serious personal injury and damage to the unit, NEVER install more than one extension boom to a power tool.

installing attachments.

Removing the Attachment or Extension Boom

1.Turn the knob counterclockwise to loosen (Fig. 1).

Release Button

Guide Recess

Craftsman Convertible™

Coupler

4.Turn the knob clockwise to tighten (Fig. 3).

CAUTION: Lock the release button in the primary hole (Fig. 2) and securely tighten the knob before operating this unit.

5.Repeat steps 1–4 for the attachment or extension boom.

Knob

Fig. 3

Knob

Fig. 1

2.Press and hold the release button (Fig. 1).

3.While firmly holding the upper shaft housing, pull the attachment or extension boom out of the coupler (Fig. 2).

Installing the Attachment or Extension Boom

1.Remove the hanger or shipping cap from the top of the shaft housing.

2.Turn knob counterclockwise to loosen (Fig. 1).

3.While firmly holding the attachment or extension boom, push it straight into the coupler (Fig. 2).

NOTE: Aligning the release button with the guide recess will help installation (Fig. 1).

CAUTION: The attachments with the coupler system is to be used in the primary hole only. Using the wrong hole could lead to personal injury or damage to the unit.

The attachment should be installed with the release button in the primary hole.

Check Flex Shaft Engagement Prior to Using

1.Start the unit.

2.Briefly engage and release the trigger.

3.Check that attachment is operating.

4.If the attachment is not operating, remove attachment and repeat steps for installing the attachment.

5.Recheck operation of attachment.

5