Sears 33731 manual Attach the Grass BAG Assembly, Using the Grass BAG

ASSEMBLY AND OPERATION

WARNING

Before installing this accessory, shut the engine off and allow it to cool. Disconnect the spark plug wire from the spark plug. Refer to the mower’s Operator’s Manual for complete safety instructions. Do not operate the mower without the entire grass bag in place. Turn the mower off and disconnect the spark plug before emptying the grass bag.

WARNING

The operation of any lawn mower can result in foreign objects being thrown into the eyes, which can damage your eyes severely. Always wear safety glasses while operating the mower, or while performing any adjustments or repairs on it.

Attach THE GRASS BAG ASSEMBLY

1.Shut the engine off and disconnect spark plug. Lift the chute deflector on the deck back towards engine, Figure 9.

2.Place the bottom lip of the chute/grass bag assembly into the lip on the deck, Figure 9.

3.Place the tab of the chute/grass bag assembly into the bracket on the deck, Figure 9

4.Lift chute/grass bag to position hole in chute over stud on the deck. The bracket on the chute will hold the chute deflector into an upright position, Figure 9

5.Push the latch over the bracket on the deck, Figure 9.

1

2

43

5

Figure 9

USING THE GRASS BAG

Empty the bag when 3/4 full.

1.To remove the grass bag, lift discharge chute, lift chute/bag assembly from stud and remove assembly from opening in deck. After the grass bag assembly has been removed from the mower’s deck, remove the grass bag assembly (along with the hanger rod) from the right side support.

2.Unzip the bag and empty.

3.Zip the bag closed and reinstall entire assembly following “Attaching the Grass Bag Assembly” above. Check the grass bag frequently for deterioration and wear. Replace worn bag with new bag.