![](/images/new-backgrounds/1027730/277303x1.webp)
CONTENTSINTRODUCTION
INTRODUCTION/WARRANTY | 2 |
SAFETY | |
INSTALLATION | |
OPERATION | 4 |
ELECTRICAL | |
MAINTENANCE | 5 |
SERVICE | |
PARTS | 8 |
Please read our instructions before you install and use your new pump; this will help you obtain full value and good ser- vice from it. It will also help you avoid needless service costs that result from causes we cannot control and cannot cover
in our warranty.
GENERAL SAFETY
Carefully read and follow all safety instructions in this
manual or on pump.
This is the safety alert symbol When you see this symbol on your pump or in this manual, look for one
of the following signal words and be alert to the potential for personal injury!
_ | warns about hazards that will cause serious |
personal injury, death or major property damage ff ignored.
['_ WAFININGIwarns about hazards that will or can cause se-
rious personal injury, death or major property damage if ig- nored.
It, CAUTIONIwarn s about hazards that will or can cause
minor personal injury or property damage if ignored.
The word NOTICE indicates special instructions which are
important but not related to hazards.
Electrically powered surnp pumps normally give many years of
and used. However, unusual circumstances (interruption of
power to the pump, dirt/debris in the sump, flooding that ex-
ceeds the pump's opacity, electrical or mechanical failure in
the pump, etc.) may prevent your pump from functioning normally. To prevent possible water damage due to flooding,
INFORMATION
consult your local Sears store about installing a secondary sttmp pnmp or a DC backup sump pinup. See "Service', Page
6, for information about common sump pump problems and remedies.
1.To avoid risk of serious bodily injury and property dam-
age, read safety instructions carefully before installing pump.
2.Follow local and/or national plumbing and electrical codes when installing pump.
3.[&WARNING]To avoid fatal shocks, proceed as fol-
lows if pump needs servicing:
A.Disconnect power to pump outlet box before
pulling pump cord plug. After plug is pulled, let
pump cool for 20 minutes before attempting to work
on it. Modern motors may operate at high tempera-
HIFeS.
B. Take extreme care when changing fuses. To re-
duce the chance of fatal electrical shocks, DO NOT stand in water or put your finger in the fuse socket.
C. Ground the electrical outlet box.
D.Use only an individual branch circuit with a
Ground Fault Circuit Interrupter (GFCD protected
grounded outlet for cord plug.
2