Sears 486.24009 step 4: (see figure 4), step 6: (see figure 6), step 5: (see figure 5), step 7: (see figure 7), ROD, FLOW, WHEEL, FIGURE, SPACER, WASHER, FIGURE, FIGURE

step 4:  (see figure 4)

•Assemble a spacer, a washer, a wheel (air valve facing out) and another washer onto the end of the axle that has both the large and small holes.

•Install a 1/8" x 1-1/2" cotter pin into the small hole in the end of the axle.

•Open the bail on the drive pin and install it through the wheel and the large hole in the axle. Close the bail to lock the pin in place.

1/8 x 1-1/2
COTTER PIN	WHEEL

step 6:  (see figure 6)

•Turn the spreader upright on its wheels.

•Hook the double bent end of the flow control rod through the hole in the slide gate bracket located near the bottom of the hopper.

WASHER

FIGURE 4

DRIVE PIN

SPACER

WASHER

FIGURE 6

step 5:  (see figure 5)

•Insert the end of the flow control rod with only one bend into the hole in the lever on the flow control tube assembly.

					FLOW
				OFF	CONTROL
8 76 5			ON		ROD
	43	2 1

9

10

FIGURE 5

step 7:  (see figure 7)

•Assemble the flow control mounting tube to the hitch tube using two 5/16" x 1-3/4" hex bolts and 5/16" nylock hex nuts. DO NOT TIGHTEN YET.

5/16 x 1-3/4

HEX BOLT 5/16 NYLOCK NUT

FIGURE 7

5