OFF

ON

FLOW

OFF

CONTROL

 

ARM

 

3

 

4

 

5

 

6

 

7

 

8

 

9

 

10

 

ADJUSTABLESTOP(SETTING "5")

FIGURE 13

24.Place the screen down into the hopper, sliding the edge of the screen under one of the clips. Slightly bow the screen to slide the opposite side of the screen under the other clip. See figure 14.

CLIP SCREEN

•Assemble the hitch bracket to the hitch extension bracket using two 3/8" x 3/4" hex bolts (inserted from the bottom) and two 3/8" nylock hex nuts. See figure 15.

•Assemble the hitch pin through the hitch bracket and the hitch extension bracket and secure with the hair cotter pin. See figure 15.

HITCH PIN3/8" NYLOCK HEX NUT3/8" x 3/4"

HEX BOLT

1/8" HAIR COTTER PIN

FIGURE 15

•For most vehicles, assemble the hitch extension bracket to the holes in the hitch tube shown at the top of figure 16. Use two 1/4" x 1-3/4" hex bolts and 1/4" nylock hex nuts tightened only finger tight. Attach the spreader hitch to your vehicle hitch. Check for interference with the spreader directly behind and out to both sides of the vehicle. Lift the spreader at each position to make sure there is no interference with the spreader's flow control. If there is interference with the rear of the vehicle, assemble the hitch extension bracket as shown at the bottom of figure 16. Tighten the bolts and nuts when finished.

CLIPS

FIGURE 14

1/4" NYLOCK

HEX NUT

FIGURE 16

1/4" x 1-3/4"

HEX BOLT

9