![Behind Refrigerator](/images/new-backgrounds/66053/6605325x1.webp)
7oif tapeholdsbottomdrawer cover to drawer supports, remove the tape Pull drawer partway out. Reach in,
push the rear of the glass up and, at the same time, back, until it clears
8, Tilt and remove the cover
9.Tilt and remove the drawer
After cleaning, replace drawers and covers in
reverse order Reinstall the
gasket at the rear of the top drawer. Fit the end of the plastic drawer support into the slot on the gasket, with the rubber gasket flap facing you Make sure the gasket snaps into place
Behind Refrigerator
Take care moving your refrigerator away from the wall All types of floor coverings can be damaged, particularly cushioned coverings and those with embossed surfaces Pull the refrigerator slraight out and return it to position by pushing it straight in Moving refrigerator in a side direction may damage floor covering or refrigerator
Light Bulb Replacement
Unplug the refrigerator before changing a llght bulb,
Fresh Food Compartment--Upper Light
!.Pull off temperature control knobs
Pin
Drain Opening in Freezer Compartment
When cleaning, remove the freezer bin and flush
a solution of baking soda (one teaspoon) and two cups of hot [not boiling) water through the drain
fine with the help of a meat baster This will
help eliminate odor and
reduce the likelihood of a clogged drain line
If drain becomes dogged, use a meat baster and
Condenser
The condenser is located behind the base grille, For most efficient operation, remove the base grille
and sweep away or vacuum up dust that [s readily accessible For best results, use a brush special}y
designed for this purpose. It is available at your Sears store or service center. This easy cleaning operation should be done at least once a year
2.Pull the bottom of the light shield down and forward, then rotate the top up and off
3o After replacing with same size bulb, reinstall light shiefd
Fresh Food
This light is Iocated behind a shield atthe rear of the _:reshbad compartment
1.Grasp the top edge of the shield and llft it up and forward to Freeits top edge
2.After replacing with same size bulb, hook the top of the shield back in place
Freezer Compartment
1_ Remove she}f iust below
light panel (Shelf will be easier to remove if it is
emptied first )
2.Pull plastic light panel
toward you, (It will bend to free tabs from grooves,)
3, After replacing with same size bulb, reinstall panel and shelf.
13