BEFORE USING WATER FROM YOUR WATER PURIFIER FOR THE FIRST TIME
continued from page 3
The remaining water will boil and pass through the system as steam to clean all surfaces.
10.The Purifier shuts off automatically when the water has boiled away (no more steam coming out of
spout...takes about 3 hours). After this time, unplug the power cord at the wall outlet.
11. Shake the storage bottle, then discard the 2 or 3
cupfuls of water which may have some harmless carbon fines (very fine black particles) in it from the
filter.
MAKING PURIFIED WATER
1.Set the Purifier on your countertop or table.
2.Unplug the cover cord from its receptacle (FIG. 1). Holding by the top strap, lift the cover to remove, and set aside.
3.Fill the tank with tap water up to the max. fill line (4 quarts). The purifing cycle is shortened if you USE HOT WATER.
NOTE: You can purify less than the full amount. Use this chart as a guide. DO NOT fill the tank with
more than 4 quarts of water because the storage bottle will overflow.
WHEN | YOU FILL WITH | THE CYCLE TAKES | |||
COLD | WATER TO... | ABOUT... |
| ||
1 qt. |
| 1 | hr., 35 min. | ||
2 | qt. |
| 3 | hrs., 5 min. | |
3 | qt. |
| 4 | hrs., 35 | min. |
4 | qt. (max. fill line) | 6 | hrs., 5 | rain. | |
4.Put the cover on the Purifier and plug the cover cord into the receptacle.
5.Check to be sure the cover spout containing the carbon filter is locked in place.
6.Set the storage bottle (cap removed) with the opening right under the spout.
7.Plug the power cord into any 120 volt outlet.
8.Press the RESET button. The fan motor in the cover begins to run (check the cover cord
When the cycle is over the Purifier turns off automati- cally. AFTER THE FAN MOTOR GOES OFF, WAIT AT LEAST 30 MINUTES BEFORE REMOVING THE COVER...
WARNING: NEVER REMOVE THE COVER WHILE THE FAN MOTOR IS RUNNING, OR FOR 30 MINUTES AFTER IT STOPS. YOU COULD GET SEVERE BURNS FROM THE BOILING WATER OR STEAM.
9.Unplug the Purifier power cord from the wall outlet.
10.Replace the cap on the storage bottle and store in the refrigerator until you neet it.
11.After the Purifier has cooled (wait for 30 minutes
after the fan motor stops running) remove the cover and clean the tank. BE SURE TO HOLD THE COVER
BY THE TOP STRAP AS YOU REMOVE IT
CARE AND CLEANING OF YOUR WATER PURIFIER
WARNING
ALWAYS BE SURE TO UNPLUG THE PURI- FIER POWER CORD FROM THE WALL OUTLET BEFORE CLEANING, OR BEFORE REPLACING PARTS.
STAINLESS STEEL TANK
INSIDE - After each use, rinse the inside with luke- warm tap water and remove any residue. If a deposit starts to form at the bottom, use Sears Distiller cleaner, Stock No.
CAUTION: DO NOT IMMERSE THE PURIFIER
IN WATER.
OUTSIDE - Wipe the outside of your Purifier with a soft sponge and mild soap.
NOTICE
THERE ARE NO USER SERVICEABLE PARTS
INSIDE. RETURN THE PURIFIER TO AUTHO- RIZED SERVICE PERSONNEL FOR REPAIR (SEE PAGE 6).
CHANGING THE CARBON FILTER
The carbon filters in the cover spout (FIG. 2, page 5), remove odors from the purified water. Replace the
continued, page 5
