Replacement and Care of Filters
WARNING: To reduce the risk of shock or Injury from moving parts, always unplug humidifier before removing or replacing any parts.
CAUTION: To help retard bacteria growth and keep maximum efficiency, the filters should be replaced at least once per season, or more often under hard water conditions, Use Sears rec- ommended replacement filter
All filters may be dnsed in deer water only, Take care not to damage paper. To replace evaperative wicking filters in your Kenmore Quiet Comfort Whole House humidifier, fol- low the Instructions below.
1.Unplug humidifier and proceed to clean.
Before removing the fitters, we recom- mend moving the humidifier to an area where floor coverings are not suscepti- ble to water damage, i.e. kitchen or bath areas.
2.To remove parts
Remove the fan assembly by opening the pivoting lid. Grasp the fan assem- bly front center and rear center. Lift off and set aside on a clean flat surface.
The filler housing assemblies are now accessible.
NOTE: There are two filter housing
assemblies. Each assembly con- elata of a top filter housing and a front filter housing. The front filter housing contains tabs that secure
the top filter housing. Do not remove the front filter housings.
3.To remove top filter housing, deflect the two vertical tabs on top of front fil- ter housing and lift up and out of cabi- net. With a soft, absorbent cloth remove any remaining water or loose mineral deposits not trapped in the fil- ter from the filter housing assemblies.
4.Remove the two filters and dispose of properly. Repeat for other top filter housing. Clean internal parts of humid-
ifier per the =Cleaning of Humidifier" section of this owner'smanual.
Pivoting
Lid
Fan
Roat
Top Rlter //_Retalner
Housln_Float
Tab on
Front oa6Qo a_ a_
Filter
Housln_
Front of Humidifier
(top view)