#7600058 TRANSMISSION PULLEY KIT FOR SEARS / SIMPLICITY ZT RIDING MOWERS
! | WARNING | ! |
DO NOT attempt any adjustments, maintenance, repairs, or service with engine running. Stop engine. Engage parking brake. Remove key. Remove spark plug wire and secure wire away from spark plug. Engine, muffler and surrounding areas are extremely hot. Avoid serious burns; allow components to cool down before installing kit. Replace worn or damaged parts prior to operating. Use approved fuel container. DO NOT smoke near open fuel container. DO NOT fill fuel tank indoors or when engine is running. Allow engine to cool for at least ten minutes before refilling. Make sure that fuel cap is tightened securely. Wipe off any spilled fuel before starting engine.
| Kit Contents - 7600058 Transmission Pulley Kit | ||
7027266 | - | 1732224 | - Transmission Belt (1) |
7101716 | - Engine Pulley (1) | 7072080 | - Wire Tie (1) |
7101717 | - Clutch Retainer (1) |
|
|
STEP 1: Lower the mowing deck to its lowest cutting posi- tion. Refer to the unit’s Operator’s Manual for instructions.
STEP 2: Remove the mowing deck belt from the electric clutch pulley. Refer to the unit’s Operator’s Manual for instructions.
STEP 3: Carefully cut the wire tie securing the electric clutch harness to the clutch retainer. Then disconnect the electric clutch harness from the unit’s main electric harness. See Figure 1.
STEP 4: Remove the hardware securing the electric clutch to the engine shaft. Remove the clutch and clutch key from the engine shaft. See Figure 1.
Remove idler spring end
FIGURE 2
STEP 7: Remove the engine pulley assembly from the engine shaft, and replace with the engine pulley assembly supplied with this kit. See Figure 3.
Disconnect harness
Remove hardware and clutch
FIGURE 1
STEP 5: Remove the forward end of the transmission idler spring from the shoulder bolt mounted to the underside of the unit. See Figure 2.
STEP 6: Remove the transmission belt from the engine pulley and the two transmission pulleys. See Figure 3.
Note: The transmission belt is retained in the idler assembly by the idler belt guide, and therefore cannot be removed from the idler assembly at this time.
Remove
belt
Replace with
supplied
engine pulley
FIGURE 3
INSTRUCTION No. 7101803 (I.R. 10/31/2007) TP 200-5303-IR-AT-SC
1