4.See the inset drawing. Remove the rubber bands from the screws. Be sure that the Arm Brackets (31) inside the tubes on the left side of the Base (1) are pressed against the indicated sides of the tubes.
Align the posts on the Left Armrest (6) with the tubes on the Base (1). Slide the Left Armrest onto the Base. You may need to flex the posts away from the Left Side Shield (8) to assemble it past the Bracket Screws (32) in the Base.
Attach the Pillow (13) to the fastener strip.
5.Raise the footrest by pulling on the Footrest Control Arm (23, not shown). Attach the lower end of the Right Side Shield (7) to the right side of the Base (1) with two Arm Cover Screws (35).
Attach the lower end of the Left Side Shield (not shown) to the left side of the Base (1) with two Arm Cover Screws (not shown).
Using the included allen wrench, tighten the four Bracket Screws (32) in the right side of the Base (1).
Tighten the four Bracket Screws (not shown) in the left side of the Base (1).
6.Plug the cord from the Hand Control (22) into the socket on the back of the massage chair. Be sure to align the indicated tabs.
4 |
|
|
13 |
|
|
6 |
|
|
|
| 8 |
|
| 32 |
| 1 |
|
31 | 1 | 31 |
5 |
|
|
7 | 32 |
|
35 |
|
|
32 |
|
|
1 |
|
|
Note: Parts of the chair are cut away for clarity | ||
6 |
|
|
| Tabs |
|
22 |
|
|
|
| Socket |
7
