Sears 917.372852 manual Assembly, To Assemble and Attach Grass

ASSEMBLY

i i i UlllU iiii iii u, i i iii 1,1, ,1, illU lU, i u ii ii i i i i

TO ASSEMBLE AND ATTACH GRASS

CAI'CHER (See Figs. 3A thru 4)

•Insert leg of tubular frame through front opening of grass catcher and thread frame into sewn hem of bag,

NOTE: Keep bag hem gathered on the straight leg of the tubutar frame

•When frame comes out the other end of sewn hem, immediately work the end of frame down inside the bag as shown in inset.

°Slide sewn hem evenly around the tubular frame until both ends of frame are exposed out of the front open- ing.

•Assemble iower frame to tubular frame as shown. Be

sure hand+e is outside of bag and frames are fully seated as shown in inset

°Slip vinyl bindings over frame

NOTE: If vinyl bindings are too stiff, hold them in warm water for a few minutes if bag gets wet, let it dry before using.

•Close the flip lid. Ftip lid must be closed while operating lawn mower

•Lift the rear door on the mower housing and place the grass catcher frame onto the formed tabs on the rear door hinge bracket..

•The grass catcher is secured to the lawn mower housing when the rear door is lowered onto the grass catcher frame..

FIG. 3C

CAUTION: Do not run your lawn mower					DOOR
without	clipping deflector	or approved
grass	catcher in place. Never		attempt
to operate the lawn mower		with	the rear	BRACKET	GRASS
door removed or propped open.
					CATCHER
					FRAME
TUBULAR FRAME	SEWN
					\

FORMED

TABS

FIG. 4

SEWN HEM FLIP LID

FIG, 3A

7