Sears 919.32721 Problem, Cause, Correction, Engine will not start No electrical output

PROBLEM CAUSE CORRECTION

Engine will not start

No electrical output

Repeated circuit breaker tripping

Generator overheating

No auto idle

DC does not have power with the

circuit breaker depressed

1.	Low on fuel or oil.		1.	Add fuel or oil.
2.	Ignition switch in "Off"	position.	2.	Turn to	"ON" position
3.	Faulty spark plug.		3.	Replace	spark plug.
4.	Choke in wrong position.		4.	Adjust choke		accordingly.
5.	Fuel shut-off valve in closed		5.	Open fuel shut-off			valve.
	position.
6.	Unit loaded during start-up.		6.	Remove load from			unit.
7.	Spark plug wire loose.		7.	Attach wire to spark				plug.
1.	Faulty receptacle.		1.	Have Service		Center		replace.
2.	Circuit breaker kicked	out.	2.	Depress and		reset.
3.	Defective capacitor.		3.	Have Service		Center replace
				capacitor.
4.	Faulty power cord.		4.	Repair or replace			cord.

5.GFCI switch breaker kicked out (if 5. Depress and reset equipped)

1.	Overload	1=	Reduce load.
		2.
2.	Faulty cords or equipment.		Check	for damaged,			bare, or
			frayed	wires on equipment.
			Replace.
1.	Generator overloaded.	1.	Reduce		load.
2.	Insufficient ventilation.	2.	Move to		adequate supply of
			fresh air.
1.	Faulty solenoid	1.	Have Service			Center	replace.
2.	Faulty idle control switch	2.	Have Service			Center	replace.
3.	Faulty windings in stator	3.	Have Service			Center	replace.
4.	Faulty circuit board	4.	Have Service			Center	replace.
5.	Faulty wire harness	5.	Have Service			Center	replace
1.	Faulty rectifier	1.	Have Service			Center	replace.
2.	Faulty windings in stator	2.	Have Service			Center	replace.
3.	Faulty wire harness	3.	Have Service			Center	replace.

16 -- ENG