PRODUCT SPECIFICATIONS
Serial | Number: |
|
|
|
|
|
Date of Purchase: |
|
|
|
|
| |
Gasoline Capacity | / Type: | 1.0 | Quarts | (unleaded | regular) | |
Oil Type | SAE | 30 (above 32°F); | SAE | |||
Oil Capacity: |
| 20 Ounces |
|
| ||
Spark | Plug (Gap: | .030") | Champion | RJ19LM |
| |
Blade | Bolt Torque: |
|
| |||
•The model and serial numbers will be found on a decal on the rear of the mower housing. Record both serial number and date of purchase in space provided above
LAWN MOWER
Always observe safety rules when
performing any maintenance.
TIRES
•Keep tires free of gasoline, oil, or insect control chemicals which can harm
rubber.
•Avoid stumps, stones, deep ruts, sharp objects and other hazards that may
cause tire damage.
BLADE CARE
For best results, mower blade must be
kept sharp. Replace bent or damaged blades.
TO REMOVE BLADE
1.Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with spark plug.
2.Turn lawn mower on its side. Make sure air filter and carburetor are up.
3.Use a wood block between blade and mower housing to prevent blade from
turning when removing blade bolt. NOTE; Protect your hands with gloves and/or wrap blade with heavy cloth.
4.Remove blade bolt by turning counter- clockwise.
5.Remove blade and attaching hard- ware (bolt, lock washer and hardened washer).
NOTE: Remove the blade adapter and check the key inside hub of blade adapter. The key must be in good condition to work properly. Replace adapter if damaged.
TO REPLACE BLADE
1.Position the blade adapter on the engine crankshaft. Be sure key in adapter and crankshaft keyway are aligned.
2.Position blade on the blade adapter aligning the two (2) holes in the blade with the raised lugs on the adapter.
3.Be sure the trailing edge of blade
(opposite sharp edge) is up toward the engine.
4.Install the blade bolt with the lock washer and hardened washer into blade adapter and crankshaft.
5.Use block of wood between blade and
lawn mower housing and tighten the blade bolt, turning clockwise.
•The recommended tightening torque is
IMPORTANT: Blade bolt is grade 8 heat treated.
TO SHARPEN BLADE
NOTE: We do not recommend
sharpening blade - but if you do, be sure the blade is balanced.
Care should be taken to keep the blade balanced. An unbalanced blade will cause eventual damage to lawn mower or engine.
•The blade can be sharpened with a file or on a grinding wheel. Do not attempt to sharpen while on the mower.
•To check blade balance, drive a nail into a beam or wall. Leave about one
inch of the straight nail exposed. Place center hole of blade over the head of
the nail. If blade is balanced, it should remain in a horizontal position. If either end of the blade moves downward, sharpen the heavy end until the blade
is balanced. | Crankshaft |
Blade ada | t keyway |
Lockwasher |
|
Blade |
|
Blade |
| 3rank |
bolt | Hardened | shaft |
12 | washer | Trailing edge Blade adapter |
