ASSEMBLY
Assembly requires two people. Place all parts of the elliptical glider in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires that you have two adjustable wrenches | , a rubber mallet | , and | |
the included allen wrench | . |
|
|
1.Identify the Front Stabilizer (18), which is the nar- rowest Stabilizer. If there are no Stabilizer Endcaps (20) on the Front Stabilizer, push one onto each end.
Attach the Front Stabilizer (18) to the front of the Frame (1) with two M8 x 63mm Carriage Bolts (49) and two M8 Nylon Locknuts (50).
2.If there are no Stabilizer Endcaps (20) on the Rear Stabilizer (19), push one onto each end.
Attach the Rear Stabilizer (19) to the Frame (1) with two M8 x 63mm Carriage Bolts (49) and two M8 Nylon Locknuts (50).
3.While a second person holds the Upright (2) near the Frame (1), connect the Extension Wire (47) to the Reed Switch Wire (41).
Insert the Upright (2) into the Frame (1), being care- ful to avoid damaging the wires. Make sure that the Frame Bushings (3) are inserted fully into the Frame. Adjust the Upright (2) so that a bolt can be inserted through the center hole in each side. Secure the Upright with two M8 x 38mm Button Bolts (53) and two M8 Nylon Locknuts (50).
1 | 50 | |
| ||
1 |
| |
50 |
| |
| 18 | |
20 | 20 | |
| ||
| 49 | |
2 |
| |
| 20 | |
| 50 | |
1 |
| |
50 | 19 | |
| ||
20 | 49 | |
| ||
3 | 2 | |
| ||
| 3 | |
3 |
| |
47 | 50 | |
| ||
41 | 1 | |
50 | ||
53 | ||
|
6
