Sears F10 Application Field Wiring, Factory, Sub-Base, Direct Line Voltage LOW Voltage

The burner may be controlled using either a DIRECT LINE VOLTAGE control circuit (120V AC 60 cycle) OR a LOW VOLTAGE control (24V AC 60 cycle) using a R8038A Honeywell switching relay or equivalent.

Using the appropriate diagram below, make electrical connections to burner. All wiring must be done in accordance with existing electrical codes, both national and local.

When all electrical connections have been made, the control box may be put back in place on the sub-base.

I WARNING:made, or failureDO NOToftheactivatepump shaftburner sealuntilmayproperoccur.oil line connections have been

APPLICATION FIELD WIRING

DIRECT LINE VOLTAGE LOW VOLTAGE

	I	Eli	FUSE	15A			FUSE15A
W	I	_ O ,/LINE		SAFETY			o/	LINE	SAFETY
		o/	SWITCH		_	F	_---_'f	SwiTCH
	_1	_- , /	OPERATING		ZC_	_	_,%6/	OPERATING
	_1	__O/	UMiTSwITCH		OD	_"	__f	LiMITSWiTCH
					-r	_	S _)/	SAFETY
					1..-	z	::z:/	LIMIT	SWITCH
					<		t
					uJ
	/	i l	SAFTET_wiTCH					]	?WITCHING RELAY

FACTORY

WIRED

SUB-BASE

VAL

z

2

DI

K

_1 CAP OR

D5995

REMOTE SENSING OF SAFETY LOCKOUT: The SAFETY SWITCH in the 530SE CONTROL BOX is equipped with a contact allowing remote sensing of burner lockout.

The electrical connection is made at terminal 4 (O) on the SUB-BASE. Should lockout

occur the 530SE CONTROL BOX will supply a power source of 120Vac to the con- nection terminal. The maximum allowable current draw on this terminal (4) is 1 Amp.

I WARNING:BOX on the Ifburneraneutralwill orbegrounddamagedlead shouldisattachedlockoutto thisoccurterminal,. the CONTROL

F10- 6