For use with the following microwave
hetallation of Bottom Bracket
1= Disconnect power from microwave oven before proceeding with installation=
2= Remove any loose items from inside the microwave
oven,
3.Fasten bottom bracket to bottom duct using 1/2"screws (supplied).
4.Turn microwave upside down and place on a protected surface.
oven ACM2160A and UMC5200AA
3= Remove any oil or dirt on the surface of the microwave oven where ductwork will be secured.
4= Peel off the protected backing on the double sided tape.
5= Place the existing screw through the ductwork and start securing the screw DO NOT TIGHTEN. Slowly push the ductwork towards the microwave keeping proper alignment of the ductwork= Press down firmly to secure the ductwork and tighten the screw securely.
Fo_oq
Existin_._ screw
Preparing for Anti-Tip Bracket
| 1= | Fold or cut the edges from the template | a!ong the |
|
| guide lines. |
|
| 2= | Place the template along the front edge | of the cutout |
|
| floor, centering the template from sideStoSside= | |
| 3= | Mark the hole positions of the antiStip bracket. | |
| 4= | Remove the template and drill two holes | for antiStip |
Fr°nt o l | \\ | bracket. Use a drill bit no larger than 7/64tto make | |
holes= |
| ||
|
|
|
5= Attach bottom duct to bottom of microwave using 1/2Tscrews (supplied)=
6= Turn microwave oven and bracket right side up, placing it on a protected surface.
hetaHation of Vented Ductwork
1= Remove screw located on left side of microwave below vent louvers.
2= Secure side duct to upper duct, by inserting metal tabs on upper duct into slots on side duct and bending tabs upward as indicated in the following illustration=
Upper | Tabs |
duct |
|
5= Place antiStip bracket onto the cutout floor and secure using 1/2"screws.
1/2" screws
Side | ||
duct | ||
|