25
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while
the resistance is adjusted to the highest level, the drive
belt may need to be adjusted.
To adjust the drive belt, first see assembly step 16 on
page 13. Use a flat screwdriver to remove the Shield
Cover (75) and the Shield Cover Cap (118).
Next, see assembly step 15 on page 13 and remove
the Right Upper Body Leg Outer and Inner Covers (69,
83).
Then, see assembly step 12 on page 11 and remove
the Right Pedal Arm (58) from the Right Upper Body
Leg (60).
See EXPLODED DRAWING C on page 31 and
EXPLODED DRAWING A on page 29. Remove the
Right Roller Arm (59) from the right Crank Arm (20).
Then, carefully remove the Right Roller Arm assembly
from the elliptical.
See EXPLODED DRAWING C on page 31. Remove
the M4 x 19mm Screws (5) and the M4 x 48mm Screw
(107) from the Left and Right Shields (73, 74). Then,
remove the Right Shield.
Next, locate and loosen the Idler Screw (89). Next,
tighten the Belt Adjustment Screw (91) until the Drive
Belt (113) is tight. Then, retighten the Idler Screw.
Reattach the right shield, the right roller arm, the right
pedal arm, the shield cover cap, and the shield cover.
113
91
89