ENFORCER
Overview: | Screw | Base | Ring bracket |
| (1 Shown, 3 included) |
| (inside the ceiling wa l) |
Camera ball
Flange
Female BNC connector
DC Plug with | DC Jack |
| |
terminal block |
|
| Flange | Base | Ring bracket |
|
|
|
|
|
| ||
Before Starting: |
|
|
| ||
1. | Please read this manual carefully and keep it for | 4. | Do not point the camera at the sun. Heat could damage | ||
| future reference. |
|
|
| the camera, even when not in use. |
2. | Use the camera within given temperature and | 5. | Do not mount the camera in areas exposed to | ||
| electrical limits. |
|
|
| radiation, strong magnetic fields, or strong |
3. | Do not mount the camera where it is exposed to rain or |
| electrical signals. | ||
| other moisture, or in humid or dusty places. | 6. | Do not drop the camera or subject it to strong vibrations | ||
Installation:
1.Run a 12VDC power supply wire and a video cable with a male BNC connector to the wall or ceiling where the camera is to be mounted.
2.Temporarily connect the camera to the 12VDC power supply.
3.Temporarily connect the camera’s female BNC connector to the video cable’s male BNC connector.
4.While watching the monitor, hold the camera against the wall or ceiling by hand where it is to be mounted, then turn the camera until it is certain that this mounting location is correct. Use a pencil to mark the location.
5.Disconnect the 12VDC power supply and video cable.
6.Drill a 21/4” (56m) hole in the ceiling or wall where the camera is to be mounted.
7.Twist the flange off the base and remove the camera ball.
8.Place the ring bracket behind the hole.
Note: Ring bracket is not necessary if mounting directly to wall.
9.Push the base into the hole, and secure to the ring bracket using the three supplied marking screws.
10.Run the power supply and video cable through the wall or ceiling to the hole, and through the bracket and base. Connect to the camera’s power and video connectors.
11.Hold the ball in the base, and secure with the flange. Do not tighten securely.
12.Apply the power to the camera. Watch the monitor and adjust the angle of the lens.
13.Secure the camera by tightening the flange.
14.Do a final test of the video camera and monitor.
3 |
