Seiko Group FB 380 user manual Options Description, Font

Options	Description
FONT	Set the font for the printer to use in the absence of any font control
	instructions from your software.
PITCH	Set the pitch to determine the horizontal spacing of the printed characters.
LINE SPACING	Set the vertical spacing of the printed characters. You can set it to either 6
	LPI (the default setting) or 8 LPI.
FORM LENGTH	Set the length of your printer paper, for both cut sheets and continuous-feed
	paper.
PAGE SKIP	Select (ON) or cancel (OFF, the default) a bottom margin of one inch.
COMPRESS PRT	Select compressed print mode or normal print mode.
TEXT DIR	Set unidirectional or bi-directional printing for text. Bi-directional (the default)
	is faster because the print head prints in both directions. Unidirectional is
	slower but produces better printing quality.
GRAPHIC DIR	Set unidirectional or bi-directional printing for graphics. It is set to UNI-DIR
	by default for better quality.
SLASH ZERO	Select or cancel the printing of a slash (/) through zero to distinguish them
	from the letter O.
CHARACTER SET	Select character set into Italic Character Table or Graphic Character Table.
INTL CHAR SET	Select among international character sets.
CODE PAGE	Select a code page
QUIET MODE	Select the printer into quiet mode. The acoustic noise is lower but the
	printing speed is reduced by half.
AUTO LF	Select (ON) or cancel (OFF) the automatic advance of the paper by one line
	after every carriage return command.
AUTO TEAR OFF	Enable or disable AUTO TEAR OFF function. The feed delay for the tear-off
	advance can be set.
LOADING	This determines the action of the printer while the single sheet paper is front
	feeding.
	PUSH KEY disables automatic loading allowing loading only by pressing the
	LF/FF key. The other options allow automatic feeding after the stated delay
	time.
SKEW DETECTION	Enable or disable the skew detection for front feeding
SKEW LEVEL	Sets the skew sensor sensitivity. 001 is the most critical while 010 is the
	least. If a skew error is detected the single sheet will be automatically
	ejected.
	Table 5-2 Description of options

22