Seiko Group UB-R02 user manual Introduction, Features and Functions, Part Names, DIP Switches

UB-R02 User’s Manual 410462701

Copyright © Seiko Epson Corporation 2004

Printed in China 2004.01

Introduction

The UB-R02 is an interface board on which is installed an IEEE 802.11b Radio Frequency (RF) module for EPSON® TM printers.

This manual provides instructions, including a simple setup for operators of POS systems in which the UB-R02 is installed so that the operators can use the UB-R02 safely and correctly.

Key to Symbol

The symbol in this manual is identified by its level of importance, as defined below. Read the following carefully before handling the product.

Note:

Notes have important information and useful tips on the operation of your equipment.

Features and Functions

❏64/128-bit WEP

❏Protocols: TCP, UDP, ICMP, IP, LP/LPR (for APD), TCP socket port (for OPOS)

❏Transfer rate: up to 11 Mbps, depending on operating environment

❏OPOS, APD support

Part Names

The following view shows the part names of the UB-R02.

Push button	Drawer kick-out	Power supply
	connector	connector

Note: This photograph shows the TM-T88III printer with the UB-R02 installed.

DIP Switches

When using this interface board, the interface of the TM printer must be selected as “parallel” with the appropriate settings. Set the reset signal for pin 31 to “enable,” if you are using a TM printer that has this setting. Refer to the manual for each TM printer for details.

1