Seiko Instruments DPU-S445 Infrared communication by IrDA

- 31 -

 Infrared communication by IrDA

(1) Turn the printer off.

(2) Turn the printer on without connecting the interface cable to it.

(3) Place the infrared transmitter/receiver of the host device and the infrared

transmitter /receiver of the printer as shown in the figure.

(4) Check communication status from the host device.

(5) Send data from the host device to the printer. Verify that the printer prints it

correctly.

NOTE

- The host device must conform to IrDA (Ver. 1.2) or BHT-Ir protocol.

HINT

• The positions shown in the figure are for reference. The best positions

depend on the model and environmental conditions.

Keep the host device and the infrared

transmitter/receiver of the printer horizontal.

10～15cm

15°

Contents

Main DPU-S445 SERIES DPU-S445 SERIES THERMAL PRINTER USERS GUIDE Page Page INTRODUCTION SAFETY PRECAUTIONS WARNING CAUTION Symbol Examples WARNING Page CAUTION Page Precautions in the Battery pack (Option) WARNING CAUTION OPERATING PRECAUTIONS Using the Printer Thermal Paper Handling Notations Used in this Users Guide Page 1 PREPARATION 2 EACH PART OF PRINTER Page Lamp Display Display Pattern : On, : Off 3 POWER CONNECTION Installing a Battery Pack Page Connecting the AC Adapter 4 PAPER SETTING Setting Cut Sheets CAUTION Setting Paper roll 5 TEST PRINTING 6 FUNCTION SETTING Function Setting Mode Changing Settings (1) Initializing software DIP switch settings (2) Changing software DIP switch settings Operation 3: Exiting function setting mode - 26 - Software DIP Switch Setting List : Factory settings DIP switch 1 Posi -tion Function Setting - 27 - Posi- tion Function Setting - 28 - DIP switch 3 Posi- tion Function Setting TF50KS-E2D (TP-341L-1) DIP switch 4 Posi -tion Function Setting 7 CONNECTING TO THE HOST DEVICE Serial/USB Communication with an Interface Cable Infrared communication by IrDA Bluetooth-based Wireless Communication (Bluetooth supported model) WARNING 8 RECHARGING THE BATTERY PACK Recharging the Battery Pack in the Printer Recharging with Specified Battery Charger Page 9 THERMAL HEAD MAINTENANCE Cleaning the Thermal Head 10 TROUBLESHOOTING The power does not turn on. The printer does not print. The ERROR lamp is lit or the POWER lamp blinks. The battery pack Is not installed. 11 SPECIFICATIONS Printer Specifications Specified AC Adapter Interface Specifications Serial interface Item Specification Connector signals Pin Signal I/O List of Compliance with Regulation List of Specified AC cable Countries Model*1 Maker - 41 - 12 OPTIONS AND CONSUMABLE PARTS Options Model Maker Remark Name Model