Manuals / Sennheiser / Home Audio / Headphones

Sennheiser HMEC 26-2 The control units of the HMEC, Control unit, BOOM switch L /R, 1 2 3 4 5 6

Models: HMEC 26-2

1 32

Download 32 pages 46.37 Kb

Page 10

The control units of the HMEC 26-2

The control units of the HMEC 26-2

The control units of the HMEC 26-2

Control unit I

	1 Volume controls
	2 LED
	3 NoiseGard™ ON/OFF switch
	4 Mono/stereo switch /
	5 BOOM switch L/R
	6 3.5 mm jack socket
	7 Battery compartment
	8 2.5 mm jack socket
Headset with	Operating element
control unit I	1 2 3 4 5 6 7 8
Cable -BV-K-2
Cable -B-K-2
Cable -B-KP-2
Cable -B-CP-2
Cable -V-KX-2

HMEC 26-2 9

Image 10

Sennheiser HMEC 26-2 The control units of the HMEC, Control unit, BOOM switch L /R, 1 2 3 4 5 6, NoiseGard ON/ OFF switch

Contents

HMEC Important safety information Preventing health problems and accidentsPreventing damage to the product and dysfunctions Only clean the product with a soft, dry clothIntended use Intended use of the product includesThe HMEC 26-2 headset FeaturesPackage contents Flipping away one earcup OperationPutting on the headset OperationPositioning the microphone Turning the microphone boomAdjusting the microphone sensitivity Adjusting the volume directly on the audio systemHearing damage due to high volumes Control unit 5 BOOM switch L /RThe control units of the HMEC 1 2 3 4 5 6The control units of the HMEC Control unit1 2 3 4 5 Headset withUsing the headset Switching NoiseGard on/offSwitching between mono and stereo mode Adjusting the volumeChanging the left and right stereo channel Activating the “auto shut-off” function Powering NoiseGard via two rechargeable batteriesMeaning Switching the TalkThrough function on/off HMEC 26-2-T only Set the switch to the position ASOConnecting a mobile telephone Danger of accident due to reduced attentionConnecting an additional audio player Attaching the belt clip Using the headset Attaching the cable clip18 HMEC Cleaning and maintaining the headset Care and maintenanceReplacing the ear pads Put the new headband paddings around the headbands Replacing the headband paddingsCare and maintenance Attach the new headband paddings by joining the fastenings stripsAccessories and spare parts AccessoriesAccessories and spare parts Spare partsCable clip Audio cable, length 0.6 m 2 x 3.5 mm stereo jack plugProduct and cable variants Cat. No Product and cable variantsModel Part NumberProduct and cable variants These headsets can be combined with all cables see page1 2 3 4 5 6 7 8 9 A B C D E F G HMECHeadphones SpecificationsSpecifications 26 HMECMicrophone incl. preamplifier SpecificationsHMEC General dataCable -CP, -CP-2, -B-CP-2 Connector assignmentCable -V-KX-2 Cable -NPCable -KP, -KP-2, -B-K-2, -B-KP-2, -BV-K-2 Cable -RP-2Cable -DP-2 Cable -B-K-2In compliance with the following requirements WarrantyManufacturer Declarations In compliance withSennheiser electronic GmbH & Co. KG