CONDENSERMICROPHONE ACCESSORIES

MICROPHONE-CRAVATEAPINCEMKH 124, MKH 125T, MKH 126 P48

Batteryadapters

Battery adapter MZA 15

Can be connected into the micro-

phone line at any point. Fitted with 9 mercury cells Mallory RM 625, it provides a continuous operation for 50 to 60 hours. The mercury cells can be purchased in all shops with cater for the hard of hearing. To prevent an unnecessary discharge of the batteries, the battery adapter should be unscrewed

from the microphone when it is not in use.

Dimensions in mm: 220 x 132.

Battery adapter MZA 15-U Fitted with Cannon connector

XLR-3-11 C and plug XLR-3-12 C

for use with the MKH-U types. Batteries as in MZA 15.

Special feature: If the plug and connector are connected to-

gether the battery condition is indicated by ~ built-in signal diode. T0 prevent an unnecessary discharge of the batteries the battery adapter should be unscrewed

from the microphone when it is not in use.

Dimensions in mm: 220 x 152.

Power supplies

Power unit MZN 16 T and T-U

For simultaneous powering of two microphones. Connection to

220 volt or 110 volt supplies. The unit can be included in the micro-

phone cable at any point. Model T-U with Cannon connectors.

Dimensions in mm: 168x120x50.

AC Power Supply MZN 16 P 48 and MZN 16 P 48-U

The power supply is designed for 48 V phantom powering, according

to engineering standard DIN 45596. ModelMZN 16 P48 is

used with condenser microphones of the MKH . . . P 48 type, while model MZN 16 P48-U is equipped with XLR connector for condenser

microphones of the

MKH . . . P 48-U type. Both models will supply power to two micro-

phones simultaneously. Dimensions in mm:

168 x 120 x 50.

Auxiliary units

Transistor amplifier KAT 15-2 For the connection of condenser

microphones, or symmetricallow impedance dynamic micro- phones, to the line and accessory inputs respectively, ofthe Nagra 111 or Nagra IV. Selected functions:

T = condenser microphones N = dynamic microphones

A switchable footlall filter is in- cluded.

Dimensions in mm: 85 x 40 x 25.

Roll-off-filter MZF 15

The roll-olf-filter MZF 15 should

be included only between supply voltage source and amplifier input. Frequency reduction

at 50 Hz approx. 6 dB at 25Hz;S; 15dB

Dimensions in mm: 22 0 x 152.

Cables

Connecting cable KA 1 and KA 7 Tripie eonductor sereened cable. Fitted with 3 pin conneetors aeeording to DIN 41524.

KA 1: 1.5 m long, KA 7: 7.5 m long.

Connecting cable KA 7-1

For use with all Sennheiser micro-

phones with the sulfix U. The

KA 7-1 is fitted on one end with a cannon female connector, the other end is free for the connection of the necessary plug. The cable is 7.5 meters long.

Connecting cable KAM 1-5 For the connection of series 6

microphones to the "Mikroport" transmitters SK 1007,

SK 1008 and the SER 1. The

microphones are powered from the transmitter.

KAM 1-5: 1 m long.

Introduction

L'element micro MK 12 est un micro-cravate a pince electrostatique HF, avec un diaphragme de 6 mm de diametre. Conformement a son utili- sation,le micro est un capteur de pression, a directivite omnidirectionnelle

et pour cette raison insensible aux bruits d'origine mecanique. Le micro complet est compose de deux elements: un element micro et un element

haute-frequence. L'element micro MK 12 est le me me pour le MH 124, MH 125 T, MH 126 P 48 ou I'emetteur de studio SK 1007. Un cordon prolongateur MZV 125 entre I'elementmicro et I'element HF est disponible en accessoires.

Notices techniques

Montage haute-frequence

Contrairement au montage basse frequenee, la eapsule d'unmiere electrostatique a haute frequence presente une faible impedance. A la piace de la tension de polarisation relativementeJevee, la capsule n'est sou mise qu'aune faible tension d'environ 10 volts, fournie par un oseilla- teur (8 MHz) a faible bruit de fond. La faible irnpedanee du systeme a pour eonsequenee un bruit de fond tres faible et une haute fiabilite

des mierophones.

Types

MK 12 + MH 124 = MKH 124

Le MKH 124 est prevu pour le raceordement direet a I'emetteurMieroport SK 1008-3.L'alimentation est assuree par I'emetteur.

MK 12 + MH 125T = MKH 125T

Further general aceessories e. g. tripods, booms, table stands etc. can be found in our catalogue "Sennheiser-revue".

Le MKH 125 Test prevu pour le raecordement ades cäbles alimentes par eonducteurs de modulation. C'estSenn heiser qui a introduit I'alimenta-

16

17