SPECIAL ACCESSORIES FOR MKH 416 T

Power supplies

Cables

Power unit MZN 16T andT-U

Connecting cable KA 1 and KA 7

Windshield MZW 415

The foam-rubber-windshield

should be drawn over the sound

inlets of the microphone when wind disturbances are evident.

Largest diameter: 52 mm,

Length: 210 mm,

Reduction of wind disturbance:

approx. 15 dB

Microphone Clamp MZQ 415

The clamp can be fitted on tri-

pods, booms etc. with 3/8" th reads.

Swivel Mount MZG 415

The swivel mount gives the possibility to use the desk stand together with the microphone

For simultaneous powering of two mierophones. Connection to

220 volt or 110 volt supplies. The unit can be included in the

microphone cable at any point. Model T-U with Cannon con-

neetors.

Dimensions in mm:

168 x 120 x 50.

Tripie eonductor screened cable. Fitted with 3 pin conneetors according to DIN 41524.

KA 1: 1.5 m long

KA 7: 7.5.m long.

Shock Mount MZS 415

The shock mount can be con-

nected to all tripods, booms, etc. with 3/8" threads and prevents recordings being disturbed by footfall or other strong mechanical disturbances.

Diameter: 35 mm, Length: 80 mm.

clamp or the shock mount for the MKH 416 T.

Desk Stand MZT 441

The MZT 441 is together with the swivel mount MZG 415 and

the microphone clamp MZQ 415 or the shoek mount MZS 415 a stable desk stand for the

MKH 416 T.

Auxiliary units

Transistor amplifier KA T 15-2

For the conneetion of condenser microphones, or symmetrieallow impedanee dynamie micro- phones, to the line and accessory inputs respectively, of the Nagra 111or Nagra IV. Selected funetions:

T = condenser microphones

N = dynamic microphones

A switehable footfall filter is in- eluded. Dimensions in mm:

85 x 40 x 25.

Roll-off-filter MZF 15

Conne~ting cable KAM 1-5 For the eonnection of series 6

mierophones to the "Mikroport" transmitters SK 1006, SK 1007, SK 1008 and the SER 1. The

microphones are powered from the transmitter.

KAM 1-5: 1 m long.

Connecting cable KA 7-1

CONDENSER MICROPHONE ACCESSORIES

The aeeessories given here are intended for use with Sennheiser transistor condenser microphones of the series . . . 6 T or . . .6 T-U.

Further general aecessories e. g. tripods, booms, table stands ete. ean be found in our catalogue "Sennheiser revue".

Battery adapters

Battery adapter MZA 15

Battery adapter MZA 15-U

The roll-olf-filter MZF 15 should be included only between supply voltage source and amplifier in- put.

Frequency reduction

at 50 Hz approx. 6 dB at25Hz~15dB

Dimensions in mm: 220 x 152.

For use with all Senn heiser mi-

crophones with the suffix U. The KA 7-1 is fitted on one end with

a cannon female connector, the other end is free for the connec-

tion of the necessary plug. The cable is 7.5 meters long.

Can be eonnected into the microphone line at any point. Fitted with 9 mercury cells Mallory RM 625, it provides a continous operation for 50 to 60 hours. The mercury cells can be purchased in all shops which eater for the hard of hearing. To prevent an unneeessary discharge of the batteries, the battery adapter should be unserewed from the

mierophone when it is not in use. Dimensions in mm: 220x132.

Fitted with Cannon eonnector XLR-3-11 C and plug XLR-3-12 C for use with the MKH-U types. Batteries as in MZA 15. Special feature: If the plug and connector are connected together the battery eondition is indicated by a built-in signal diode. To prevent an unneeessary discharge of the batteries the battery adapter should be unscrewed from the

microphone when it is not in use. Dimensions in mm:220x152.

12

13