Sennheiser RS 125 Switching the headphones on and off

Using the RS 125 system

operation indicator 7 goes off. The transmitter is now in standby mode, its power consumption is very low so that it can remain connected to the mains.

When not using the devices for extended periods of time, pull out the mains connector from the wall socket. In this case, however, the headphones’ rechargeable batteries will not be recharged.

Switching the headphones on and off

CAUTION! Hearing damage due to high volumes!

Listening at high volume levels for long periods can lead to permanent hearing defects.

￿Before putting the headphones on, set the volume to a low level.

￿Do not continuously expose yourself to high volumes.

Switching the headphones on
￿ Set the ON/OFF switch 4on the headphones	/
to the position ON.

The headphones switch on and automatically start the channel search on the last selected channel. If a channel is found, the channel search stops. You hear the signal of the found sound source.

If you do not hear the sound source after a short while, please refer to the chapter “If a problem occurs ...” on page 18.

13