Manuals / Sennheiser / Home Audio / Headphones

Sennheiser RS 45 English, Wireless RS, Adjusting the volume, Adjusting the receiver channel

Models: RS 45

1 17
Download 17 pages 35.04 Kb
Page 3
Image 3
Adjusting the volume

English

Adjusting the volume

Set the volume of your sound source to a medium value. With some devices, the volume for the headphone output can be regulated separately.

Use the VOLUME control on the right earpiece to adjust the headphones´ volume.

Adjusting the receiver channel

First switch on the transmitter (see section Where to place the transmitter). Then switch on the headphone receiver - as soon as the receiver is switched on it automatically tunes itself to the first strong signal found (normally the transmitter frequency). If, for some reason, the selected

channel is not the correct one (eg: because of interference or another nearby system), press the

TUNE button on the earpiece and the auto-tune function will re-tune to the next strong signal. Repeat this until you can hear the audio signal loud and clear. If you decide to change the transmitter channel, the receiver search tuning must be re- started by pressing the TUNE button on the headphones again.

Changing the transmission channel To avoid interference caused by the simultaneous operation of several transmitters, select a different channel on each transmitter. Depending on the system variant, two or three switchable transmission channels are available. To select a channel, press the CHANNEL button until the desired LED or LED combination lights

up:

 

LED 1

channel 1 active

LED 2

channel 2 active

LED 1 and 2

channel 3 active (except 863 MHz version).

Complete freedom of movement

It is not necessary that transmitter and headphone receiver are in a direct line of sight, so you can move around freely in the home or outside in the garden. One transmitter can be used to transmit to several receivers on the same frequency.

Additional headphones with the designation HDR 45 are available from your specialist dealer. Please make sure to choose headphones with the same frequency range as

the transmitter you are using (see type plate on the bottom of the transmitter).

Wireless RS 45-8

Page 2 Page 4
Page 3
Image 3
Sennheiser RS 45 English, Wireless RS, Adjusting the volume, Adjusting the receiver channel, Complete freedom of movement
Page 2 Page 4

FAQ

How do I adjust the volume of Sennheiser RS 45 headphones?

Set the volume of your sound source to a medium value, then use the VOLUME control on the right earpiece to adjust the headphones volume.

How do I adjust the receiver channel for Sennheiser RS 45 headphones?

Switch on the transmitter, then switch on the headphone receiver. If the selected channel is not the correct one, press the TUNE button on the earpiece to re-tune to the next strong signal.

Can one transmitter be used to transmit to several Sennheiser RS 45 receivers?

Yes, one transmitter can be used to transmit to several receivers on the same frequency. Additional headphones with the designation HDR 45 are also available from your specialist dealer.