Sennheiser VGA44 OPERATION

OPERATION

PAG E 6 VGA44 INSTALLATION & OPERATION MANUAL

> Before making any connections to the VGA44, observe the following:

> Ensure the mains voltage supply matches the label on the supplied

plug-pack (+/- 10%)

> Ensure that the power switch is OFF

> Ensure that all system grounds (earth) are connected to a common point.

Avoid powering equipment within a system from multiple power sources that

may be separated by large distances

> Connect all audio video sources and destination equipment

> Power up all source and destination audio-visual sources

> Power up the VGA44 VGA matrix switcher

> For each destination output select the appropriate input source by using

the front panel UP and DOWN select button, the supplied IR remote control,

or through the RS232 serial communications port

The AMAV VGA44 matrix switcher ships with a remote control. The

remote control has the following functionality:

i) Source Select Buttons

Four separate input assignment buttons are provided for each of the

four VGA outputs. The last selected input source will be routed to

the destination output. Input sources may be assigned to multiple

destination outputs

ii) Power Button

Toggles the unit into, and out of, standby mode. In standby mode the

matrix switcher will stop video routing. Standby mode is indicated by

the illumination of the front panel power LED only.

POWER

INPUT-1

Output - 1

Output - 2

Output - 3

Output - 4

INPUT-2 INPUT-3 INPUT-4

INPUT-1 INPUT-2 INPUT-3 INPUT-4

4x4 VGA Matrix Switcher

VGA44 manual.indd 6 12/3/07 2:24:59 PM