Sennheiser Wireless RS 60 English, If problems occur, Accessories, Technical data, Transmitter

English

Varnish or furniture polish may attack the rubber feet of the transmitter’s charging unit. As these could stain your furniture, place the transmitter on a non-slip pad.

If problems occur...

Are all connections properly made?

Are the headphones and sound source switched on and is the volume correctly adjusted?

Have you charged the accupack for at least 20 minutes? Are you too far from the transmitter? (if so, move closer) Choose a different channel.

Adjust the setting with the TUNE control.

If the problem persists, please contact your specialist dealer for assistance. Never open the device!

Only use original Sennheiser spare parts and accessories. Components from other manufacturers (e.g. for mains unit or accupack) may cause damage to the device and will invalidate the guarantee.

Accessories

The following accessories are available from your specialist dealer:

Spare accupack	BA 151
Charger	L 151-2
Additional headphones	HDR 60
Technical data
Modulation	FM, stereo
Transmitter
Power supply	12 V DC via plug-in mains unit
Power consumption	approx. 1 VA
RF output power	typ. up to 10 mW
	(0.75 mW with 925 MHz version)
Signal-to-noise ratio	typ. > 68 dBA
Frequency range	see type plate located on the bottom of transmitter
Channels	3 (2 with 863 MHz version)
Audio connector	3.5 mm /1/4" (6.3 mm) stereo jack plug, (925 MHz
	version supplied with jack to 2 x phono plug)
Charging compartments	1, for BA 151 accupack
Weight	approx. 186 g incl. accupack
Dimensions	approx. 155 x 153 x 105 mm
Receiver
Max. sound pressure level	100 dB
THD	< 0.5 % (at 1 kHz and nom. deviation)
Power supply	2.4 V via BA 151 accupack
Current consumption	approx. 18 mA
Operating time	more than 4 hrs per accupack
Weight	approx. 160 g incl. accupack
Dimensions	approx. 150 x 80 x 200 mm

Wireless RS 60-10