Servis-Rhino SE10-4A, SE15-4A 9.3 Cutting Component Inspection

OPERATION

SE10-4A/SE15-4A 03/09 Operation Section 4-23

OPERATION

9.3 Cutting Component Inspection

Inspect blade pan and blade assembly for the following:

OPS-U-0031_A

Check Carrier tightness

to output shaft - Torque

to 450 ft.-lbs. as required.

Check Blade Bolt

daily - Torque to

300 ft.-lbs. as

required.

Inspect the Blades daily for abnormal wear. REPLACE BOTH BLADES on that carrier

IMMEDIATELY if either blade has:

• Become bent or deformed from it’s original shape or

• Any cracks are visible, or

• Deep gouges in the blade’s surface are persent, or

• Gouges or chipped areas in the cutting edge are larger than 1/2”(12.7mm), or

• The material on the leading edge has been worn away by more than 1/2(12.7mm)”

Failure to replace abnormally worn blades may lead to catastrophic failure of the blades and ejection of the

broken part with tremendous force which may cause serious bodily injury or death. OPS-U-0032