OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS cont.
NOTE: Always remove the power plug from the wall outlet before assembling or removing accessories.
INSERTING THE 2-PIECE METAL HANDLE INTO THE MAIN BODY
•Push in the pin at the end of the lower piece of the metal handle (see illustration).
•Insert the metal handle into the hole next to the handle. Make sure that the slot in the handle fits correctly into the opening. (See illustration.)
•When inserted correctly, the pin should rest in its hole.
Pin
Pin
Hole
ATTACHING THE HOSE TO THE MAIN BODY
•Press in the pin at the end of the hose (see illustration below).
•Insert the hose into its place (see arrow in illustration).
•When inserted correctly, the pin will show in the pin hole.
Pin Hole
WINDING & UNWINDING THE POWER CORD
•To wind the cord after usage, follow the illustration below.
•To unwind the power cord, follow the illustration below but in the opposite direction.
•When using the vacuum, attach the cord to the cord holder so that the cord is out of the way when you are vacuuming. (See below.)
Top of Retractable Handle
Cord Holder
USING THE UNIT AS AN UPRIGHT
Crevice Tool
For radiators, crevices, corners, baseboards and
between cushions.
Dusting Brush
The dusting brush is used for the furniture, venetian blinds, books, lamp shades
and shelves.
Emptying The Dust Cup
Warning: Always unplug the unit from electrical outlet before opening the Dust Cup (container).
• | Hold the dust cup in your hand. |
• Turn it a complete 90° in the direction | |
| shown in drawing #1. (Turning less than |
| 90° will cause the dust cup to be |
| attached on its bottom.) |
• | Let the dust cup come down slightly as |
| shown in drawing #2. |
• | Slide the dust cup out towards you (see |
| arrow in drawing #3). |
•To insert the upper piece of the metal handle, press on the pin that is on the upper handle and insert into the lower handle making sure that the pin comes out of the pinhole on the lower handle.
ATTACHING THE FLOOR BRUSH TO THE MAIN BODY
•Push in the pin in the floor attachment as shown in the illustration at right.
•Insert the floor brush into its location, in the direction
of the arrow.
•When inserted correctly, the pin will show in the pin hole.
Pin
Hole
ON/OFF SWITCH
•The On/Off switch has two different positions.
•Push on the "I" side to turn the vacuum ON.
•Push on the "O" side to turn the vacuum OFF.
=OFF
=ON
•Unwind the power cord and plug into the 120V outlet.
•Push down in the direction of the arrow to obtain best results on carpets or on hard wood floors.
NOTE: When vacuuming deep pile carpets or hard to vacuum carpets, lower the angle of the
(see illustration at below) for easier maneuverability.
USING THE UNIT AS A HAND VACUUM
•Disconnect the metal handle. (See page 4.)
•Disconnect the floor brush. (See page 4.)
•Attach the hose. (See page 4.)
•Attach the crevice tool or the dusting brush. (See below.)
•Attach the shoulder strap. (See page 7.)
• | Hold the dust cup in your hand and |
| remove the |
| (see drawing #4). |
• | Empty the dust cup (see drawing #5). |
4
5
4
5
