Shark EP750M manual Battery Pack Replacement & Disposal, Assembly

Battery Pack Replacement & Disposal

This vacuum cleaner contains a nickel-cadmium (Ni-Cd) batteries. Batteries must be recycled or disposed of properly. Call your nearest recycling center for information on the recycling and disposal of nickel-cadmium (Ni-Cd) batteries.

If uncertain as to how to remove the battery pack, we suggest you take your hand vacuum to a reputable small appliance service technician to have this service preformed.

The battery pack of your EP750M is replaceable, however care should be taken when doing so. Follow these steps when replacement is required:

1.Remove unit from charging stand and /or remove the charging adapter jack, before changing batteries. Ensure that the “On / Off” switch is in the “Off” position.

2.Open the battery pack compartment by removing the single Phillips head screw located in the recess at the rear of the unit. NEVER open the battery compartment except to change the battery pack when required.

3.Remove battery compartment cover. Set aside battery compartment cover with the screw.

4.Carefully detach the two (2) electrical connectors from the battery pack by pulling straight out from the battery pack.

Warning: Do not place battery in a position where metal can be placed across the battery terminals as the battery pack can overheat.

5.Lift out the battery pack and set aside.

6.Insert the new battery pack and re-connect the terminals by pushing lead wires onto battery tabs.

7.Tuck the wiring inside the battery compartment so that the wiring does not interfere with the battery compartment cover when it is replaced.

8.Re-install the battery compartment cover by sliding it over the battery towards the front of the unit, making sure that the front snap engages the body of the unit.

9.Replace the battery compartment cover screw.

WARNING: NEVER use ordinary
batteries for replacement, as these may
leak and damage your vacuum cleaner.
Use only battery pack B75018 provided
by EURO-PRO Operating LLC for
replacement.
	•	CAUTION
CAUTION: NEVER use the unit		Use only with the battery pack
		supplied with the unit.
without the battery compartment cover	•	Do not attempt to remove the
in place.		battery pack from the unit to charge
		it.
	• Never attempt to throw the battery
NOTE: Any other servicing should be		pack or unit into a fire or incinerate
performed by an authorized service		it.
representative.	•	Do not attempt to remove or
		damage the battery casing.
	• Battery must be recycled or
		disposed of properly at the end of
		it's service life.

ASSEMBLY

Note: Dust cup filter (4) must be used when operating the hand vacuum.

1.To open the dust cup (container) (1), push button (2) and remove the dust cup (1). Verify that the dust cup filter (4) is inside, then re-attach the dust cup (container) (1) to the hand vacuum.

Fig. 1 Fig. 2 Fig. 3

2.To attach the convertible brush (8), or crevice tool (11) to the Hand Vacuum, push the attachment into the suction hole, as shown in Fig. 4.

Fig. 4

3.To operate the motorized brush, connect the plug of the spiral cord of the brush to the jack under the bottom of the main unit, then turn on the unit for vacuuming. (Fig. 5, 6) the spiral cord can be found in the cord storage on the motorized brush. (Fig. 7)

Fig. 5 Fig. 6

Fig. 7

4.To use the extension tubes (7) with the motorized brush (9), push the extension tube with the rubber seal (7B) into the suction hole of the dust cup , then insert the other extension tubes (7A) into each other and then insert the motorized brush (9) into the last extension tube. Operate the motorized brush as shown in Point 3 above. The convertible brush (8) and the crevice tool (11) can also be used with the extension tubes (7).

Insert extension tube with seal into dust cup suction hole

6 3