How to Use
Align arrows to attach tool caddy
Hose
Dock
Caddy
Release
Fig. 8
Fig. 1
Pull out to remove tool caddy
Fig. 4
Fig. 3
Fig. 2
Power
Button
Fig. 5
Fig. 6
Fig. 9
ASSEMBLING THE LIFT-AROUND™ CANISTER VAC
1Insert the end of the flexible hose into the connector on the front of the
2Insert the removable tool caddy onto the back of the Canister Vac. (fig. 2) To remove the tool caddy, hold the vacuum by the handle, pull out slightly from the right side and then remove it from the Canister Vac. (fig. 3)
3Insert the crevice tool, dusting brush, upholstery brush or power brush into the openings on the tool caddy. (fig. 4)
4Attach the shoulder strap onto the hooks on the handle of the Canister Vac. (fig. 5)
5Empty Dust Cup after cleaning and periodically during cleaning when it appears full. (See “Maintenance” section for instructions.)
Fig. 7
USE IN CANISTER MODE
6Place the hose in the hose dock. (fig. 6)
7Place the unit over the caddy and press down until it locks into place. (fig. 6, fig. 7)
8To release the vacuum from the caddy, press caddy release button and lift the vacuum up. (fig. 8)
FOR ADDED COMFORT OR FOR AN EXTENDED REACH
9Attach the floor kit handle to the flexible hose. Push it in until it is secure. (fig. 9)
10Insert the telescopic tube into the end of the floor kit handle. Push it in until it is secure. (fig. 9)
NOTE: All accessories may be used with the flexible hose, the floor kit handle or the telescopic tube.
11Attach the desired accessory to the end of the flexible hose, floor kit handle or telescopic tube by pushing it in until it is tightly secured. (fig. 9)
12While holding the Canister Vac by the handle, press down on the power button to turn the Canister Vac on and begin vacuuming. Press down again to turn the vacuum off. (fig. 5)
8 | TOLL FREE: |
www.sharkclean.com | 9 |
