Shark S3305 Operating Instructions, Getting To Know Your Steam Mop, Care & Maintenance, Voltage

OPERATING INSTRUCTIONS

GETTING TO KNOW YOUR STEAM MOP

Care & Maintenance

IMPORTANT: Always insure that the unit is “UNPLUGGED” from the wall receptacle prior cleaning or before emptying the water tank.

1.Turn the unit off and unplug from electrical outlet.

2.Wrap power cord around cord holders.

3.Let the unit cool for five (5) minutes before removing the micro-fiber cleaning cloth and before emptying the water tank.

4.Always empty the water tank when you have finished using the unit.

5.Never leave the micro-fiber cleaning cloth on the unit when you have finished using the steam mop. Always remove the micro-fiber cleaning cloth and wash in warm water with a mild detergent. Never use bleach or fabric softener when cleaning the micro-fiber cleaning cloth. The micro-fiber cleaning cloth can be washed in a washing machine and dried in a clothes dryer but on low heat. We recommend that you air dry for 24 hours but it could also be dried in a clothes dryer on a low heat setting.

6.Wipe the unit with a damp cloth to clean. Never immerse main unit in water or any other liquid.

7.In order to keep your steam mop in good condition, we recommend that you clean the water tank once a month to eliminate calcium deposits. Add three ounces (3 oz) of water to the water tank and shake to loosen any deposits. Remove the filling cap and immediately empty water into a sink. Do not use vinegar or other decalcifying substances in the

steam mop water tank. Caution: Do not immerse the unit in

water or any other liquids.

Helpful Hints

1.Always vacuum or sweep before steam cleaning.

2.The easiest way to use the machine is to tilt the ergonomic handle to a 45° angle and clean slowly 2-3 yards at a time.

3.Hand wash or machine wash the micro-fiber cleaning cloths in a delicate cycle with a mild detergent.

4.We recommend air drying the micro-fiber cleaning cloths for 24 hours, but they could be dried in a dryer on a low heat setting.

5.A good amount of steam passes through the micro-fiber cleaning cloth. We recommend that the cleaning cloth be changed when it gets too wet. These need to be replaced as necessary.

6.To remove stubborn stains from vinyl or linoleum floors, pre-treat with a mild detergent and some water before using the steam mop.

IMPORTANT:

Never leave the steam mop in one spot for any period of time. Always place the appliance on the floor protector pad and make sure that the appliance is turned off.

1.	Hand Grip		8.	Empty Light (Red)
2.	Power Cord		9.	Tube Pivot
3.	2-Piece Ergonomic Handle		10.	Cord Holder
4.	Filling Cap		11.	Micro-Fiber Cleaning Cloth (x2)
5.	Main Unit		12.	Filling Flask
6.	On/Off Button		13.	Floor Protector Pad
7.	Power “On” Light (Green)		14.	Handle Joint
Technical Specifications
Voltage:		120V., 60Hz.
Power:		800 Watts
Water Capacity:		8 U.S. Fl. Oz.(250ml)

Note: Illustrations may differ from actual unit.

6

3