Shark SC630W manual Quick Start

Quick Start

Your portable steam pocket is designed to clean surfaces that will withstand high heat and moisture. Do not use on unsealed wood surfaces (especially wooden antique furniture), unglazed ceramic tile, painted surfaces or surfaces that have been treated with wax, oils, varnishes, or shellac. The sheen may be removed by the heat, steam, and friction of the cleaning tools. Lacquer and polyurethane coatings provide a hard durable protective finish that withstands moisture but it is always recommended

to test an isolated area of the surface to be cleaned before proceeding. We also recommend you check the use and care instructions from the surface manufacturer.

When cleaning finished wood surfaces, use broad, continuous cleaning strokes. To prevent surface damage, avoid focusing steam or alowing the cleaning tools to sit in one spot for any amount of time.

When assembling your portable steam pocket, there may be a little water in the water tank. This is because we test all our portable steam pocket cleaning systems 100% before you buy them, so you get a quality Shark Steam product.

(Note for reference: This connection method is the same design used with most over the counter prescription bottles). The design of this connection is to prevent the hose from twisting and kinking during use.

4

9

11

DETAIL CLEANING TOOL ASSEMBLY

11 Press fit the scrubbing detail

brush onto the detail cleaning

Quick Start

2

ASSEMBLY

1Safely remove contents of the Portable Steam Pocket Cleaning System and lay them out on a flat surface to see that you have all the components to complete the assembly (Refer to page 2).

FILL

2Turn the water tank cap counter- clockwise and remove to fill, using the filling flask provided. Be careful not to overfill. Replace the cap by turning clockwise. The water tank does not have to be completely full for the steam bottle to generate steam. Steam will stop when the water tank is empty. You can refill at any time.

DIRECT SPRAY STEAM BOTTLE USE

3Attach the steam bottle nozzle. Aligning the arrow located on the steam bottle nozzle with the un-lock symbol located on the nozzle connector. Press in and turn clockwise to secure into place. The arrow on the nozzle will align with the lock symbol.

3

HOSE & CLEANING TOOL

ATTACHMENT USE

4Attach the hose connector. Aligning the arrow located on the hose connector with the un-lock symbol located on the nozzle connector. Press in and turn clockwise to secure into place. The arrow on the hose connector will align with the lock symbol.

5Select the desired cleaning tool for use. Follow the cleaning tool sub assembly Instructions for the selected tool.

6Attach the cleaning tool by inserting the hose stem into the handle of the cleaning tool. Press in and turn clockwise at the same time to secure and press in and turn counter clockwise to release. Check for proper connection by turning the handle counter-clockwise a few turns. The handle should remain connected.

6

WEDGE CLEANING TOOL ASSEMBLY

7Slide the wedge shaped cleaning pocket over the wedge cleaning tool frame until it is completely on.

8Close the cinch by pulling on the elastic band and sliding the locking bean to tighten.

CYLINDER CLEANING TOOL

ASSEMBLY

9Squeeze “chopsticks” together and slide the cylinder shaped cleaning pocket over the cylinder cleaning tool frame until it is completely on.

10Close the cinch by pulling on the elastic band and sliding the locking bean to tighten.

7

8

tool handle.

12

13

GARMENT STEAMER

ASSEMBLY

12Press fit the garment steamer onto the bottle nozzle.

13Stretch the garment steamer bonnet over the garment steamer diffuser. Attach the garment brush onto the garment steamer diffuser by aligning the bottom of the diffuser with the back of the garment brush attachment. Gently push the top of the garment brush up into place until the attachment snaps into place.

TOLL FREE: 1-800-798-7398

www.sharkclean.com