SHARK SSG • 8.914-337.0 / 97-6134 • Rev. 8/07
7

PRESSURE WASHER OPERATOR’S MANUAL

ASSEMbLy INSTRUCTIONS
STEP 1: Attach the high pressure
hose to the spray gun using teflon
tape on hose threads.
STEP 3: Release the coupler collar
and push the nozzle until the collar
clicks. Pull the nozzle to make sure
it is seated properly.
STEP 5: Connect the high pressure
hose to the pump discharge fitting.
Push coupler collar forward until
secure.
STEP 2: Pull the spr ing-loaded
collar of the wand coupler back
to insert your choice of pressure
nozzle.
STEP 6: Connect garden hose to
the cold water source.
STEP 7: Check inlet filters, remove
debris, then connect the garden
hose. CAUTION: Do not run the
pump without water or pump
damage will result.