Shark Sv769 manual Replacemen Parts for Model SV769, Assembly, Using Your Motorized Brush

Fig. 8

Fig. 9

Metal

contact

pins

Fig. 7

Dust Cup

Release

Button

OPERATING INSTRUCTIONS

OPERATING INSTRUCTIONS

Assembly

Note: The filter must always be used when operating the hand vacuum.

1.To open the dust cup container, press the dust cup release button and remove the dust cup container.

(Fig. 5)

Fig. 5

2.Verify that the filter is inside, then re- attach the dust cup container to the hand vacuum. (Fig. 6)

Fig. 6

3.To attach the crevice tool to the hand vacuum, push the

attachment into the suction hole in the

front of the dust container. (Fig. 7)

CAUTION: The suction inlet must be open and free of any obstructions at all times. Otherwise, the motor will overheat and could become damaged.

Using Your Motorized Brush

1.Make sure that the vacuum is in the "Off" position.

2. Firmly insert the

motorized brush (Fig. 8) into the

air-intake nozzle of the dust cup container ensuring that the contact pins are engaged in the connector slots of the unit. (Fig. 9)

Note: This motorized brush is for vacuuming short pile carpets, rugs or upholstery.

WARNING: Do not touch the motorized brush while it is in motion.

Using Your Cordless Vacuum

1.Unplug unit from charger.

2.To start the unit, slide the "On/Off“ switch to the "On" position.

3.To stop the hand vac, slide the "On/Off" switch to the "Off" position.

4.A crevice tool is provided for cleaning narrow, hard to reach places. A motorized brush is provided for cleaning low pile carpets or upholstery.

Changing & Cleaning the Filter

To achieve the best performance, empty the dust cup container and clean the filter after each use.

1.To remove the dust cup container, press down on the dust cup release button and pull off the dust cup container.

2.Pull out the filter.

3.Empty the dust from the dust cup container.

(Fig. 10)	Fig. 10
4. Rinse the filter in

cold water, and then wait until it air dries completely before replacing it back into the dust cup container.

Do not use a washing machine to clean the filter. Do not use a hair dryer to dry it. Air dry only.

CAUTION: The suction hole must be open, free of any obstructions at all times. Otherwise, the motor will overheat and could become damaged. Warning: Always empty the dust cup container and clean the filter before each use and during prolonged usage. Never over fill the dust cup (container) - remove dirt and clean the filter and frequently during prolonged usage or risk motor damage.

If you wash the filter, make sure that it is completely air dry before inserting back in the vacuum.

Note: The filter is washable. It should, however, be replaced every three (3) to six (6) months, depending on usage to ensure peak performance of your vacuum.

T R O U B L E S H O O T I N G G U I D E

PROBLEM	POSSIBLE REASON		POSSIBLE SOLUTION
HAND VACUUM	1 .	Batteries discharged.	1 .	Charge unit.
	2 .	No power in electrical	2 .	Check fuse or breaker .
W ILL NOT
		outlet supplying		Replace fuse/reset
OPERATE
		transformer.		breaker.
	1 . Dust cup container is		1 . Empty dust cup
				container
HAND VACUUM		full.
			2 . Remove filter and check
W ILL NOT PICK-	2 . Filter needs cleaning
				for object(s) in air duct
UP OR SUCTION		or replacement .
				and remove. Clean or
POW ER IS W EAK	3 .	Unit needs
				replace filter .
		recharging .
			3 .	Charge unit.
	1 . The 2 metal pins of		1 . Firmly insert the
				motorized brush into
		the motorized brush
				the air- intake nozzle.
MOTORIZED		are not in contact
				This will connect the
BRUSH W ILL NOT		with the vacuum
				motorized nozzle to the
W ORK		cleaner .
				unit power supply.
	2 . Motorized brush is
			2 . Remove all lint, hair etc .
		clogged up.
				from motorized brush.
	1 . Dust cup container is		1 . Empty dust cup
DUST ESCAPING		full.
				container.
	2 . Filter is not installed
FROM HAND			2 .	Review the filter
		correctly.
VACUUM				installation instructions.
	3 .	Puncture/hole in
			3 . Replace the filter.
		filter.

REPLACEMEN PARTS FOR MODEL SV769

Replacement dust cup filter SKU# XF769

Replacement battery pack SKU# XB768

To order replacement batteries or filters or for technical support:

Call: 1 (800) 798-7398

Monday to Friday 8:30 A.M. - 5:00 P.M. Eastern Standard Time

or

visit our website: www.sharkvac.com

Please Note: The filter is washable. It should, however, be replaced every three

(3) months to ensure peak performance of your vacuum.

Important: Make sure that filter has completely air dried before re-installing back in the hand vacuum.

5

6