Shark V1315 instruction manual Cleaning the Filters, Cleaning Utensil

CLEANING THE FILTERS

1 Remove the dust compartment.(refer to page 9)

Set the dust compartment to the parallel

2 position.Open the trapdoor,then push the release button E and pull out the main filter.

The main filter and prefilter will be removed at the same time.

Caution: Do not push the release button E at the upright position. As this may drop or damage the main filter and prefilter.

Release Button E

3

Clean the main filter and prefilter with a soft-bristled brush (not included) and

3 rinse with cold water. Allow both items to dry completely for 24 hours.

Caution:

Do not use a hard-bristled brush to clean filters. This may result in damage to the filters.

Do not attempt to dry with a hair dryer or by placing in a clothes dryer.Hot air may cause the filters to warp.

Cleaning Utensil

To maintain optimum suction power, the dust filter fins should be kept clean of dirt. Clean the filter fins free of dirt with the forked end of cleaning utensil as shown.

			Cleaning Utensil
	Reattaching the filters		Hold onto the main filter and insert into
	Insert the main filter into the
1 prefilter as shown.			2 the dust compartment.
			Align the ribs of the main filter to match
		Prefilter	the shape of the opening in the dust
			compartment and press firmly to insert.

Dust Compartment

Hole

Main Filter Ribs

3 Close the trapdoor.

NOTE: We recommend replacing the main filter every three (3) to six (6) months, depending on the amount of use

10