Shark V1950 manual Operating Instructions, Assembling Your Cordless Sweeper, Charging Instructions

OPERATING INSTRUCTIONS

Assembling Your Cordless Sweeper

Your cordless sweeper will require very little assembly. You should remove it from the carton and familiarize yourself with all the components listed per the exploded view drawing. (Pg. 2) This will help you in the assembly and operation of your cordless sweeper.

Note: The charging adapter will be shipped inside the packaging.

1.To assemble your sweeper, push the handle into the base. It will snap into place firmly. (Fig. 1)

Fig. 1 Fig. 2

2.To straighten the handle, simply lift the upper handle. The forward folding pivot will click into the straightened position as shown in Figure 2.

3.To fold the handle, press on the handle release button firmly while bending the handle forward. The forward folding pivot will click into the bent position as shown in Figure 3.

Fig. 3

3

OPERATING INSTRUCTIONS

Charging Instructions

1.Connect the charger plug to the charging jack or hole on the side of the sweeper. Plug the charging adapter into the wall outlet. (120V., 60Hz.) Use only charger Kuantech KA12D090015023U. (Fig. 4)

Charging

Light

Indicator

Fig. 4

2.This cordless sweeper is powered by Ni-Cd batteries. Before first use, they must be charged for a minimum 20 hours.

3.When recharging the unit, the "On/Off" switch must be in the "OFF" position.

4.The charging light indicator on the top of the sweeper will illuminate to indicate that the sweeper is properly charging.

5.To recharge, repeat step #1 above. Charging times will vary depending upon the amount of usage between charging cycles.

Note: If, when you place the sweeper to recharge and the charging indicator light does NOT illuminate, then press the On/Off button once to turn the sweeper off. The charging indicator light should now light up.

Note: Peak performance may only be realized after the unit has been charged and discharged two (2) or three (3) times.

Important: To maintain peak performance of your cordless sweeper, it is recommended that the unit be fully discharged, then completely re-charged at least once a month.

Caution:

•Use only the adaptor supplied with the sweeper.

•Do not clean the sweeper while unit is charging.

•Do not attempt to remove the battery pack from the unit to charge it.

•Never attempt to throw the battery pack or unit into a fire or incinerate it.

•Do not attempt to remove or damage the battery casing.

4