11
GENERAL PROGRAMS
OPERATION SETTINGS
The "OPERATION SETTINGS" are related to basic
operation of the machine and consist of the following
programs:
●AUTO CLEAR SETTING
●MESSAGE TIME SETTING
●KEYS TOUCH SOUND
●TOUCH KEY OPERATION SETTING
●DISABLE INTERRUPT PRINT JOB
●STREAM FEEDING MODE
●DISPLAY LANGUAGE SETTING
●DISABLE DISPLAY TIMEOUT
●DISABLING OF TRAY SETTINGS

AUTO CLEAR SETTING

If no action is taken for a certain length of time when
viewing information on finished jobs, jobs in progress,
or stored jobs, the auto clear function activates and
returns the display to the initial screen of copy mode or
the job status screen. AUTO CLEAR SETTING is used
to set the amount of time that must elapse for the auto
clear function to activate. The time can be set from 10
seconds to 240 seconds in increments of 10 seconds,
or the auto clear function can be disabled. (This setting
only operates in copy mode and network scanner
mode.)

MESSAGE TIME SETTING

This program is used to set the length of time that
messages appear in the display (this applies to
messages that appear for a certain length of time and
then automatically disappear.)
The time can be set to as long as 12 seconds in
increments of one second.

KEYS TOUCH SOUND

This program is used to select whether or not a beep is
sounded when a key is touched, and if sounded, what
type of beep.
The program is also use to select whether or not a
special key touch beep is sounded at the initial point of
a setting.
key.... Touch this key to select a
short
beep
volume. A single
short
beep indicates a
valid key, and a double
short
beep
indicates an invalid key.
key.... Touch this key to select a long beep
volume. A single long beep indicates a valid
key, and a double long beep indicates an
invalid key.
key ....Touch this key to disable key touch beeps.
Select the [KEYS TOUCH SOUND AT INITIAL POINT]
checkbox to have three long beeps sound (when the
beep volume is set to
long
) or three short beeps sound
(when the beep volume is set to
short
) when the initial
point of a setting is reached while selecting basic settings.
The initial point settings are as follows:

TOUCH KEY OPERATION SETTING

These programs are used to set the length of time that
must elapse until a setting is entered after a key is
touched, and to disable key repeat.
The setting entry time can be set from 0.0 seconds to
2.0 seconds in increments of 0.5 seconds.
When [DISABLE AUTO KEY REPEAT] is enabled, only
one touch is registered if key is touched continuously.

DISABLE INTERRUPT PRINT JOB

(When the printer function is enabled)

Enable this program if you wish to prevent pausing of
printing for interrupt copy jobs.
KEY OPERATOR PROGRAMS
OPERATION SETTINGS
MESSAGE TIME SETTING
KEYS TOUCH SOUND
OK
1/3
6sec
AUTO CLEAR SETTING 60sec
Mode
Initial point (set from initial screen)
Copy mode Ratio: 100%
Exposure: 3
Fax mode Exposure: 3
Network scanner
mode
Exposure setting: 3
KEY OPERATOR PROGRAMS
KEYS TOUCH SOUND
KEYS TOUCH SOUND AT INITIAL POINT
KEYS TOUCH SOUND
OK