Sharp CD-BA200 How To Use The Built-Intimer, Timer playback, Timer recording, Sleep operation

HOW TO USE THE BUILT-IN TIMER

●Before setting the timer, make sure that the clock setting is correct. (Page 6)

(Main unit operation)

POWER	Timer set indicator
ON/
STAND-BY
TIMER/
SLEEP
CD	TUNING/
TAPE
	TIME
(1 2)	( )
TUNER	MEMORY/
(BAND)
	SET

3

4

5

■Timer playback

1 Press the ON/STAND-BY button to turn the power on.

2 Press the CD, TUNER (BAND) or TAPE (1 V 2) button to select the desired function.

3 Press the TIMER/SLEEP button repeatedly until "f" is displayed. At this point, make sure that "REC" is not lit.

●The timer set indicator will flash.

4 Press the TUNING/TIME (X or W) button to set the hour start time, then press the MEMORY/SET but- ton.

5 Press the TUNING/TIME (X or W) button to set the minute start time, then press the MEMORY/SET but- ton.

●The power will be automatically turned off, and the timer set indicator will light up.

6 When the preset time is reached, the volume will increase gradually until it reaches the volume you were listening to before turning off the unit.

7 If you select CD or TAPE during timer playback, the power will be turned off after the tape or CD is finished playing back.

If you select TUNER (BAND), the power will be turned off one hour later.

■Timer recording

1 Press the ON/STAND-BY button to turn the power on.

●Load a cassette for recording into the TAPE 2 cassette com- partment.

2 Press the TUNER (BAND) button to select the desired fre- quency band.

3 Press the TIMER/SLEEP button repeatedly until "f" and "REC" are displayed.

●The timer set indicator will flash.

4 Press the TUNING/TIME (X or W) button to set the hour start time, then press the MEMORY/SET button.

5 Press the TUNING/TIME (X or W) button to set the minute start time, then press the MEMORY/SET button.

●The power will be automatically turned off, and the timer set indicator will light up.

6 When the preset time is reached, the timer recording will start.

●The volume will increase gradually until it reaches the volume you were listening to before turning off the unit.

7 When the recording tape reaches its end, the timer recording will end, and the power will be turned off.

To cancel timer operation:

Press the ON/STAND-BY button to turn the power on.

To change the programmed contents:

Start again from step 1.

Note:

●Once the time is set, the setting will be retained until a new time is entered.

■Sleep operation

The radio, compact disc and cassette deck can all be turned off automatically.

1 Play back the desired sound source.

2 Press the TIMER/SLEEP button repeatedly until "SLEEP" is displayed.

To change the sleep time:

While the sleep time is displayed, press the TUNING/TIME (X or W) button to adjust the time.

(Maximum: 3 hours - Minimum: 1 minute)

The amount of sleep time can also be changed during the sleep operation.

●3 hours - 5 minutes → 5-minute intervals

●5 minutes - 1 minute → 1-minute intervals

3 Press the MEMORY/SET button.

4 The unit will turn off automatically after the preset sleep time has elapsed.

Note:

●Once the sleep time is set, it will remain the same duration until the setting is changed.

To confirm the remaining sleep time:

Press the TIMER/SLEEP button.

To cancel the sleep operation:

Press the ON/STAND-BY button to enter the stand-by mode.

14