Sharp Cx68n5 operation manual Connecting to an antenna via a VCR

C X 6 8 N 5 _ 2 3 - 2 6 _ E N

F L E ( M a l a y s i a ) S d n . B h d .

Connecting to an antenna

To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections that are used for coaxial and feeder cables.

If your outdoor antenna uses a 75-ohm coaxial cable with a standard DIN45325 plug (IEC 169-2), plug it into the antenna jack at the rear of the set.

If your outdoor antenna uses a 300-ohm twin-lead flat feeder, connect a 300-ohm to 75-ohm impedance converter and plug it into the antenna jack at the rear of the set.

TV

Standard DIN45325 plug (IEC169-2)

75-ohm coaxial cable (round cable) (not supplied)

300-ohm twin-lead	75-ohm impedance
flat feeder	converter
(not supplied)	(not supplied)

Antenna in

Connecting to an antenna via a VCR

You can also connect the TV set to the tuner on a VCR using the connection shown below.

VCR TV

To antenna in terminal

To RF out terminal

Antenna in

•When using the RF terminal connection, set the TV to channel zero to make initial adjustments for the VCR.

•Turn off the power on the TV set and the VCR being connected before making the above connections. Be sure the cord plugs are fully inserted in the connection terminals.

E 25 • See the operation manual of your VCR for connection details.

D i m e n s i o n : 1 7 6 x 2 5 0 m m