Sharp ESV80HA Setting UP Electrical Connection / Water Inlet Connection, Electrical connection

CHAPTER -3: SETTING UP

ELECTRICAL CONNECTION / WATER INLET CONNECTION

Electrical connection

￿Your washing machine is set to 220-240V and 50Hz.

Water inlet connection

￿Your machine may have either a single inlet (cold) or double water inlets (cold/hot) based on its specifications. White-capped hose should be connected to cold water inlet and red-capped hose to hot water inlet (applicable for machines with double water inlets).

￿To eliminate water leakages in points of contact, 1 or 2 washers are provided in the hose package (applicable for machines with double water inlets). Fit these washers to the ends of new water inlet hoses on the side of the tap.

￿Connect the white-elbow end of the water inlet hoses to the white- filtered water inlet valve on the rear side of the machine and the red-elbow end to red-filtered one (applicable for machines with double water inlets). Tighten plastic parts of the junctions using your hand.

￿Flow of water with pressure of 0.1-1 Mpa will allow your machine to operate more efficiently (0.1 Mpa pressure means that more than 8 litres of water will flow through a fully-opened tap per one minute).

￿Ensure that new water inlet hoses are not folded, broken, crushed or their dimensions are not altered.

￿Connect new water inlet hoses to a ¾ ￿, threaded tap.

￿If your machine has double hot water inlets, the temperature of hot water inlet should not exceed 70°C.

10